RTC interrupt level should be set to "LOW". This was revealed by the
introduction of commit:
f181987ef477 ("rtc: m41t80: use IRQ flags obtained from fwnode")
which changed the way IRQ type is obtained.
Signed-off-by: Andrej Picej <andrej.picej@xxxxxxxxx>
---
arch/arm/boot/dts/imx6qdl-phytec-mira.dtsi | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/arch/arm/boot/dts/imx6qdl-phytec-mira.dtsi b/arch/arm/boot/dts/imx6qdl-phytec-mira.dtsi
index 1a599c294ab8..1ca4d219609f 100644
--- a/arch/arm/boot/dts/imx6qdl-phytec-mira.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-phytec-mira.dtsi
@@ -182,7 +182,7 @@ i2c_rtc: rtc@68 {
pinctrl-0 = <&pinctrl_rtc_int>;
reg = <0x68>;
interrupt-parent = <&gpio7>;
- interrupts = <8 IRQ_TYPE_LEVEL_HIGH>;
+ interrupts = <8 IRQ_TYPE_LEVEL_LOW>;
status = "disabled";
};
};
--
2.25.1
