Re: [PATCH v3 2/3] media: dt-bindings: alvium: add document YAML binding

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Laurent,

On Wed, Jun 07, 2023 at 10:21:34AM +0300, Laurent Pinchart wrote:
> On Wed, Jun 07, 2023 at 09:14:48AM +0200, Tommaso Merciai wrote:
> > On Tue, Jun 06, 2023 at 07:07:42PM +0100, Conor Dooley wrote:
> > > On Tue, Jun 06, 2023 at 07:36:56PM +0300, Laurent Pinchart wrote:
> > > > On Tue, Jun 06, 2023 at 05:54:03PM +0200, Tommaso Merciai wrote:
> > > 
> > > > > +  alliedvision,lp2hs-delay-us:
> > > > > +    maxItems: 1
> > > > > +    description:
> > > > > +      Low power to high speed delay time in microseconds.
> > > > 
> > > > You can drop "in microseconds", that's implied by the suffix.
> > > > 
> > > > > +      The purpose of this property is force a DPhy reset for the period
> > > > > +      described by the microseconds on the property, before it starts
> > > > > +      streaming. To be clear, with that value bigger than 0 the Alvium
> > > > > +      forces a dphy-reset on all lanes for that period. That means all
> > > > > +      lanes go up into low power state. This may help a csi2 rx ip to
> > > > > +      reset if that IP can't deal with a continous clock.
> > > > 
> > > > I'd like to propose what I think is a clearer version:
> > > > 
> > > >     description: |
> > > >       Low power to high speed delay time.
> > > > 
> > > >       If the value is larger than 0, the camera forces a reset of all
> > > >       D-PHY lanes for the duration specified by this property. All lanes
> > > >       will transition to the low-power state and back to the high-speed
> > > >       state after the delay. Otherwise the lanes will transition to and
> > > >       remain in the high-speed state immediately after power on.
> > > > 
> > > >       This is meant to help CSI-2 receivers synchronizing their D-PHY
> > > >       RX.
> > > 
> > > Question about the property.
> > > Why not make it have a minimum value of 1 and drop the special-case
> > > behaviour for zero?
> > 
> > Personally I prefer to stay with zero case.
> > This reflect better the real camera register behaviour.
> 
> Speaking of which, could you document the maximum value in the bindings
> ?

150ms is the max value I'll document this in v4.

Regards,
Tommaso

> 
> > (also is optional)
> 
> -- 
> Regards,
> 
> Laurent Pinchart



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux