Thanks
On 6/1/2023 4:15 PM, Nishanth Menon wrote:
On 15:07-20230601, Udit Kumar wrote:
Add main_uart0 pin mux in board common file
$subject is a bit misleading.. I think the intent is to mux the console
explicitly rather than a pinmux cleanup itself.
oops, missed to changed subject of this patch after split.
Will address in v3.
Signed-off-by: Udit Kumar<u-kumar1@xxxxxx>
---
arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts | 11 +++++++++++
1 file changed, 11 insertions(+)
diff --git a/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts b/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts
index 0cc0e1dc40c5..02d2e4b36b18 100644
--- a/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts
+++ b/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts
@@ -113,6 +113,15 @@ J721E_IOPAD(0xd8, PIN_INPUT_PULLUP, 0) /* (W2) I2C0_SDA */
>;
};
+ main_uart0_pins_default: main_uart0_pins_default {
+ pinctrl-single,pins = <
+ J721E_IOPAD(0xb0, PIN_INPUT, 0) /* (T16) UART0_RXD */
+ J721E_IOPAD(0xb4, PIN_OUTPUT, 0) /* (T17) UART0_TXD */
+ J721E_IOPAD(0xc0, PIN_INPUT, 2) /* (W3) SPI0_CS0.UART0_CTSn */
+ J721E_IOPAD(0xc4, PIN_OUTPUT, 2) /* (U5) SPI0_CS1.UART0_RTSn */
+ >;
+ };
+
main_i2c1_pins_default: main-i2c1-pins-default {
pinctrl-single,pins = <
J721E_IOPAD(0xdc, PIN_INPUT_PULLUP, 3) /* (U3) ECAP0_IN_APWM_OUT.I2C1_SCL */
@@ -162,6 +171,8 @@ &main_uart0 {
status = "okay";
/* Shared with ATF on this platform */
power-domains = <&k3_pds 146 TI_SCI_PD_SHARED>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&main_uart0_pins_default>;
};
&main_uart1 {
--
2.34.1
