Add StarFive JH7100 PWM controller node and add PWM pins configuration on VisionFive 2 board. Reviewed-by: Hal Feng <hal.feng@xxxxxxxxxxxxxxxx> Signed-off-by: William Qiu <william.qiu@xxxxxxxxxxxxxxxx> --- .../boot/dts/starfive/jh7100-common.dtsi | 24 +++++++++++++++++++ arch/riscv/boot/dts/starfive/jh7100.dtsi | 9 +++++++ 2 files changed, 33 insertions(+) diff --git a/arch/riscv/boot/dts/starfive/jh7100-common.dtsi b/arch/riscv/boot/dts/starfive/jh7100-common.dtsi index b93ce351a90f..746867b882b0 100644 --- a/arch/riscv/boot/dts/starfive/jh7100-common.dtsi +++ b/arch/riscv/boot/dts/starfive/jh7100-common.dtsi @@ -84,6 +84,24 @@ GPO_I2C2_PAD_SDA_OEN, }; }; + pwm_pins: pwm-0 { + pwm-pins { + pinmux = <GPIOMUX(7, + GPO_PWM_PAD_OUT_BIT0, + GPO_PWM_PAD_OE_N_BIT0, + GPI_NONE)>, + <GPIOMUX(5, + GPO_PWM_PAD_OUT_BIT1, + GPO_PWM_PAD_OE_N_BIT1, + GPI_NONE)>; + bias-disable; + drive-strength = <35>; + input-disable; + input-schmitt-disable; + slew-rate = <0>; + }; + }; + uart3_pins: uart3-0 { rx-pins { pinmux = <GPIOMUX(13, GPO_LOW, GPO_DISABLE, @@ -154,6 +172,12 @@ &osc_aud { clock-frequency = <27000000>; }; +&ptc { + pinctrl-names = "default"; + pinctrl-0 = <&pwm_pins>; + status = "okay"; +}; + &uart3 { pinctrl-names = "default"; pinctrl-0 = <&uart3_pins>; diff --git a/arch/riscv/boot/dts/starfive/jh7100.dtsi b/arch/riscv/boot/dts/starfive/jh7100.dtsi index 000447482aca..977a509ffbdd 100644 --- a/arch/riscv/boot/dts/starfive/jh7100.dtsi +++ b/arch/riscv/boot/dts/starfive/jh7100.dtsi @@ -238,5 +238,14 @@ i2c3: i2c@12460000 { #size-cells = <0>; status = "disabled"; }; + + ptc: pwm@12490000 { + compatible = "starfive,jh7100-pwm"; + reg = <0x0 0x12490000 0x0 0x10000>; + clocks = <&clkgen JH7100_CLK_PWM_APB>; + resets = <&rstgen JH7100_RSTN_PWM_APB>; + #pwm-cells = <3>; + status = "disabled"; + }; }; }; -- 2.34.1