Sony have advised that there are variants of the IMX258 sensor which require slightly different register configuration to the mainline imx258 driver defaults. There is no available run-time detection for the variant, so add configuration via the DT compatible string. The Vision Components imx258 module supports PDAF, so add the register differences for that variant Signed-off-by: Dave Stevenson <dave.stevenson@xxxxxxxxxxxxxxx> --- drivers/media/i2c/imx258.c | 49 ++++++++++++++++++++++++++++++++++---- 1 file changed, 45 insertions(+), 4 deletions(-) diff --git a/drivers/media/i2c/imx258.c b/drivers/media/i2c/imx258.c index 986757650378..98b5c1e3abff 100644 --- a/drivers/media/i2c/imx258.c +++ b/drivers/media/i2c/imx258.c @@ -6,6 +6,7 @@ #include <linux/delay.h> #include <linux/i2c.h> #include <linux/module.h> +#include <linux/of_device.h> #include <linux/pm_runtime.h> #include <linux/regulator/consumer.h> #include <media/v4l2-ctrls.h> @@ -320,8 +321,6 @@ static const struct imx258_reg mipi_642mbps_24mhz_4l[] = { static const struct imx258_reg mode_common_regs[] = { { 0x3051, 0x00 }, - { 0x3052, 0x00 }, - { 0x4E21, 0x14 }, { 0x6B11, 0xCF }, { 0x7FF0, 0x08 }, { 0x7FF1, 0x0F }, @@ -344,7 +343,6 @@ static const struct imx258_reg mode_common_regs[] = { { 0x7FA8, 0x03 }, { 0x7FA9, 0xFE }, { 0x7B24, 0x81 }, - { 0x7B25, 0x00 }, { 0x6564, 0x07 }, { 0x6B0D, 0x41 }, { 0x653D, 0x04 }, @@ -459,6 +457,33 @@ static const struct imx258_reg mode_1048_780_regs[] = { { 0x034F, 0x0C }, }; +struct imx258_variant_cfg { + const struct imx258_reg *regs; + unsigned int num_regs; +}; + +static const struct imx258_reg imx258_cfg_regs[] = { + { 0x3052, 0x00 }, + { 0x4E21, 0x14 }, + { 0x7B25, 0x00 }, +}; + +static const struct imx258_variant_cfg imx258_cfg = { + .regs = imx258_cfg_regs, + .num_regs = ARRAY_SIZE(imx258_cfg_regs), +}; + +static const struct imx258_reg imx258_pdaf_cfg_regs[] = { + { 0x3052, 0x01 }, + { 0x4E21, 0x10 }, + { 0x7B25, 0x01 }, +}; + +static const struct imx258_variant_cfg imx258_pdaf_cfg = { + .regs = imx258_pdaf_cfg_regs, + .num_regs = ARRAY_SIZE(imx258_pdaf_cfg_regs), +}; + static const char * const imx258_test_pattern_menu[] = { "Disabled", "Solid Colour", @@ -643,6 +668,8 @@ struct imx258 { struct v4l2_subdev sd; struct media_pad pad; + const struct imx258_variant_cfg *variant_cfg; + struct v4l2_ctrl_handler ctrl_handler; /* V4L2 Controls */ struct v4l2_ctrl *link_freq; @@ -1134,6 +1161,14 @@ static int imx258_start_streaming(struct imx258 *imx258) return ret; } + ret = imx258_write_regs(imx258, imx258->variant_cfg->regs, + imx258->variant_cfg->num_regs); + if (ret) { + dev_err(&client->dev, "%s failed to set variant config\n", + __func__); + return ret; + } + ret = imx258_write_reg(imx258, IMX258_CLK_BLANK_STOP, IMX258_REG_VALUE_08BIT, imx258->csi2_flags & V4L2_MBUS_CSI2_NONCONTINUOUS_CLOCK ? @@ -1490,6 +1525,7 @@ static int imx258_probe(struct i2c_client *client) struct v4l2_fwnode_endpoint ep = { .bus_type = V4L2_MBUS_CSI2_DPHY }; + const struct of_device_id *match; int ret; u32 val = 0; @@ -1565,6 +1601,10 @@ static int imx258_probe(struct i2c_client *client) imx258->csi2_flags = ep.bus.mipi_csi2.flags; + imx258->variant_cfg = of_device_get_match_data(&client->dev); + if (!match) + imx258->variant_cfg = &imx258_cfg; + /* Initialize subdev */ v4l2_i2c_subdev_init(&imx258->sd, client, &imx258_subdev_ops); @@ -1653,7 +1693,8 @@ MODULE_DEVICE_TABLE(acpi, imx258_acpi_ids); #endif static const struct of_device_id imx258_dt_ids[] = { - { .compatible = "sony,imx258" }, + { .compatible = "sony,imx258", .data = &imx258_cfg }, + { .compatible = "sony,imx258-pdaf", .data = &imx258_pdaf_cfg }, { /* sentinel */ } }; MODULE_DEVICE_TABLE(of, imx258_dt_ids); -- 2.25.1