Hi Dmitry,
Thank you for the patch.
On Sun, May 07, 2023 at 11:12:16PM +0300, Dmitry Baryshkov wrote:
> Follow the dp-connector example and add hdmi-pwr supply to drive the 5V
> pin of the HDMI connector (together with some simple glue logic possibly
> attached to the connector).
>
> Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
> ---
> .../devicetree/bindings/display/connector/hdmi-connector.yaml | 3 +++
> 1 file changed, 3 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/display/connector/hdmi-connector.yaml b/Documentation/devicetree/bindings/display/connector/hdmi-connector.yaml
> index 83c0d008265b..94f75359c6ff 100644
> --- a/Documentation/devicetree/bindings/display/connector/hdmi-connector.yaml
> +++ b/Documentation/devicetree/bindings/display/connector/hdmi-connector.yaml
> @@ -36,6 +36,9 @@ properties:
> description: GPIO signal to enable DDC bus
> maxItems: 1
>
> + hdmi-pwr-supply:
> + description: Power supply for the HDMI 5v pin connector
I'd write
description: Power supply for the HDMI +5V Power pin
to match the HDMI specification. With that,
Reviewed-by: Laurent Pinchart <laurent.pinchart@xxxxxxxxxxxxxxxx>
> +
> port:
> $ref: /schemas/graph.yaml#/properties/port
> description: Connection to controller providing HDMI signals
--
Regards,
Laurent Pinchart
