J721E common processor board has an onboard mux for selecting whether
the OSPI signals are externally routed to OSPI flash or Hyperflash. The
mux state signal input is tied to WKUP_GPIO0_6 and is used by bootloader
for enabling the corresponding node accordingly. Add pinmux for the same.
Signed-off-by: Vaishnav Achath <vaishnav.a@xxxxxx>
---
arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts | 11 +++++++++++
1 file changed, 11 insertions(+)
diff --git a/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts b/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts
index 7db0603125aa..b7a2f23b2c67 100644
--- a/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts
+++ b/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts
@@ -363,6 +363,12 @@
J721E_WKUP_IOPAD(0xb8, PIN_INPUT, 7) /* (F28) WKUP_GPIO0_2 */
>;
};
+
+ wkup_gpio_pins_default: wkup-gpio-pins-default {
+ pinctrl-single,pins = <
+ J721E_WKUP_IOPAD(0xd0, PIN_INPUT, 7) /* (C14) WKUP_GPIO0_8 */
+ >;
+ };
};
&wkup_uart0 {
@@ -420,6 +426,11 @@
status = "disabled";
};
+&wkup_gpio0 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&wkup_gpio_pins_default>;
+};
+
&wkup_gpio1 {
status = "disabled";
};
--
2.17.1
