- Enable "vibr" and "vsim2" regulators to power the ethernet chip. Tested-by: Kevin Hilman <khilman@xxxxxxxxxxxx> Signed-off-by: Alexandre Mergnat <amergnat@xxxxxxxxxxxx> --- arch/arm64/boot/dts/mediatek/mt8365-evk.dts | 57 +++++++++++++++++++++++++++++ 1 file changed, 57 insertions(+) diff --git a/arch/arm64/boot/dts/mediatek/mt8365-evk.dts b/arch/arm64/boot/dts/mediatek/mt8365-evk.dts index 913e09545030..5a4c41dbd3a5 100644 --- a/arch/arm64/boot/dts/mediatek/mt8365-evk.dts +++ b/arch/arm64/boot/dts/mediatek/mt8365-evk.dts @@ -88,6 +88,28 @@ optee_reserved: optee@43200000 { }; }; +ðernet { + pinctrl-0 = <ðernet_pins>; + pinctrl-names = "default"; + phy-handle = <ð_phy>; + phy-mode = "rmii"; + /* + * Ethernet and HDMI (DSI0) are sharing pins. + * Only one can be enabled at a time and require the physical switch + * SW2101 to be set on LAN position + */ + status = "disabled"; + + mdio { + #address-cells = <1>; + #size-cells = <0>; + + eth_phy: ethernet-phy@0 { + reg = <0>; + }; + }; +}; + &i2c0 { clock-frequency = <100000>; pinctrl-0 = <&i2c0_pins>; @@ -137,12 +159,47 @@ &mt6357_pmic { #interrupt-cells = <2>; }; +/* Needed by analog switch (multiplexer), HDMI and ethernet */ +&mt6357_vibr_reg { + regulator-always-on; +}; + /* Needed by MSDC IP */ &mt6357_vmc_reg { regulator-always-on; }; +/* Needed by ethernet */ +&mt6357_vsim2_reg { + regulator-always-on; +}; + &pio { + ethernet_pins: ethernet-pins { + phy_reset_pins { + pinmux = <MT8365_PIN_133_TDM_TX_DATA1__FUNC_GPIO133>; + }; + + rmii_pins { + pinmux = <MT8365_PIN_0_GPIO0__FUNC_EXT_TXD0>, + <MT8365_PIN_1_GPIO1__FUNC_EXT_TXD1>, + <MT8365_PIN_2_GPIO2__FUNC_EXT_TXD2>, + <MT8365_PIN_3_GPIO3__FUNC_EXT_TXD3>, + <MT8365_PIN_4_GPIO4__FUNC_EXT_TXC>, + <MT8365_PIN_5_GPIO5__FUNC_EXT_RXER>, + <MT8365_PIN_6_GPIO6__FUNC_EXT_RXC>, + <MT8365_PIN_7_GPIO7__FUNC_EXT_RXDV>, + <MT8365_PIN_8_GPIO8__FUNC_EXT_RXD0>, + <MT8365_PIN_9_GPIO9__FUNC_EXT_RXD1>, + <MT8365_PIN_10_GPIO10__FUNC_EXT_RXD2>, + <MT8365_PIN_11_GPIO11__FUNC_EXT_RXD3>, + <MT8365_PIN_12_GPIO12__FUNC_EXT_TXEN>, + <MT8365_PIN_13_GPIO13__FUNC_EXT_COL>, + <MT8365_PIN_14_GPIO14__FUNC_EXT_MDIO>, + <MT8365_PIN_15_GPIO15__FUNC_EXT_MDC>; + }; + }; + gpio_keys: gpio-keys-pins { pins { pinmux = <MT8365_PIN_24_KPCOL0__FUNC_KPCOL0>; -- 2.25.1