On 8.03.2023 22:35, Konrad Dybcio wrote: > v1 -> v2: > - Use CLK_IS_CRITICAL instead of leaving a clk enable vote, expand macros > to do so > - Fix the keepalive clocks for 8998 & 660 (CNoC -> PNoC, it was > confusingly named cnoc_periph downstream) > - Introduce .determinte_rate to ensure we don't set keepalive clocks' > rates below 19.2 MHz > - Add a (!conditional!) way to test the ultimate goal of all these changes > by essentially enabling unused clk cleanup through a dt property (for > legacy reasons) > > v2 was tested on: > > - MSM8996 Sony Kagura (can disable unused) > - MSM8998 Sony Maple (can disable unused with OOT icc) > - SM6375 Sony PDX225 (can disable unused with OOT icc) > > v1: https://lore.kernel.org/r/20230303-topic-rpmcc_sleep-v1-0-d9cfaf9b27a7@xxxxxxxxxx > > This series brings support for a couple of things necessary for the full > system idle on SMD RPM SoCs, namely unused clk shutdown and keepalive > votes (permanent active votes that are required on certain clocks for the > platform to function). > > Tested on MSM8996 and SM6375, does not seem to introduce any additional > regressions. > > Keepalive clocks for other platforms were gathered by digging in old > downstream kernels, please give them a test. > > Signed-off-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxx> > --- > Konrad Dybcio (11): > dt-bindings: clock: qcom,rpmcc: Add a way to enable unused clock cleanup > clk: qcom: smd-rpm_ Make __DEFINE_CLK_SMD_RPM_BRANCH_PREFIX accept flags > clk: qcom: smd-rpm: Make DEFINE_CLK_SMD_RPM_BRANCH_A accept flags > clk: qcom: smd-rpm: Make BI_TCXO_AO critical Stephen, parallel to all of the discussions, would you be willing to take patches 4-6 as they are? XO_A being critical is something that won't hurt without the rest. Konrad > clk: qcom: smd-rpm: Make __DEFINE_CLK_SMD_RPM_PREFIX accept flags > clk: qcom: smd-rpm: Separate out a macro for defining an AO clock > clk: qcom: smd-rpm: Add support for keepalive votes > clk: qcom: smd-rpm: Introduce DEFINE_CLK_SMD_RPM_BUS_KEEPALIVE > clk: qcom: smd-rpm: Hook up PCNoC_0 keep_alive > clk: qcom: smd-rpm: Hook up CNoC_1 and SNoC_2 keep_alive > arm64: dts: qcom: msm8996: Enable rpmcc unused clk disablement > > Shawn Guo (3): > clk: qcom: smd-rpm: Add .is_enabled hook > clk: qcom: smd-rpm: Add .is_prepared hook > clk: qcom: smd-rpm: Mark clock enabled in clk_smd_rpm_handoff() > > .../devicetree/bindings/clock/qcom,rpmcc.yaml | 6 + > arch/arm64/boot/dts/qcom/msm8996.dtsi | 1 + > drivers/clk/qcom/clk-smd-rpm.c | 133 +++++++++++++++------ > 3 files changed, 106 insertions(+), 34 deletions(-) > --- > base-commit: fc31900c948610e7b5c2f15fb7795832c8325327 > change-id: 20230303-topic-rpmcc_sleep-d67aad9f3012 > > Best regards,
