All Qualcomm SoC Top Level Mode Multiplexer pin controllers have similar capabilities regarding pin properties, thus we can just accept entire set provided by qcom,tlmm-common.yaml schema. Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx> --- .../bindings/pinctrl/qcom,mdm9607-tlmm.yaml | 11 +---------- 1 file changed, 1 insertion(+), 10 deletions(-) diff --git a/Documentation/devicetree/bindings/pinctrl/qcom,mdm9607-tlmm.yaml b/Documentation/devicetree/bindings/pinctrl/qcom,mdm9607-tlmm.yaml index 96b598bf9a76..2aedb7e7bc8b 100644 --- a/Documentation/devicetree/bindings/pinctrl/qcom,mdm9607-tlmm.yaml +++ b/Documentation/devicetree/bindings/pinctrl/qcom,mdm9607-tlmm.yaml @@ -54,6 +54,7 @@ $defs: Pinctrl node's client devices use subnodes for desired pin configuration. Client device subnodes use below standard properties. $ref: qcom,tlmm-common.yaml#/$defs/qcom-tlmm-state + unevaluatedProperties: false properties: pins: @@ -105,19 +106,9 @@ $defs: uim1_clk, uim1_data, uim1_present, uim1_reset, uim2_clk, uim2_data, uim2_present, uim2_reset, uim_batt, wlan_en1, ] - bias-disable: true - bias-pull-down: true - bias-pull-up: true - drive-strength: true - input-enable: true - output-high: true - output-low: true - required: - pins - additionalProperties: false - examples: - | #include <dt-bindings/interrupt-controller/arm-gic.h> -- 2.34.1