On Fri, Mar 31, 2023 at 10:35 AM Neil Armstrong
<neil.armstrong@xxxxxxxxxx> wrote:
>
> Due to lack of maintainance and stall of development for a few years now,
> and since no new features will ever be added upstream, remove the
> OX810 and OX820 gpio bindings.
>
> Signed-off-by: Neil Armstrong <neil.armstrong@xxxxxxxxxx>
> ---
> .../devicetree/bindings/gpio/gpio_oxnas.txt | 47 ----------------------
> 1 file changed, 47 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/gpio/gpio_oxnas.txt b/Documentation/devicetree/bindings/gpio/gpio_oxnas.txt
> deleted file mode 100644
> index 966514744df4..000000000000
> --- a/Documentation/devicetree/bindings/gpio/gpio_oxnas.txt
> +++ /dev/null
> @@ -1,47 +0,0 @@
> -* Oxford Semiconductor OXNAS SoC GPIO Controller
> -
> -Please refer to gpio.txt for generic information regarding GPIO bindings.
> -
> -Required properties:
> - - compatible: "oxsemi,ox810se-gpio" or "oxsemi,ox820-gpio"
> - - reg: Base address and length for the device.
> - - interrupts: The port interrupt shared by all pins.
> - - gpio-controller: Marks the port as GPIO controller.
> - - #gpio-cells: Two. The first cell is the pin number and
> - the second cell is used to specify the gpio polarity as defined in
> - defined in <dt-bindings/gpio/gpio.h>:
> - 0 = GPIO_ACTIVE_HIGH
> - 1 = GPIO_ACTIVE_LOW
> - - interrupt-controller: Marks the device node as an interrupt controller.
> - - #interrupt-cells: Two. The first cell is the GPIO number and second cell
> - is used to specify the trigger type as defined in
> - <dt-bindings/interrupt-controller/irq.h>:
> - IRQ_TYPE_EDGE_RISING
> - IRQ_TYPE_EDGE_FALLING
> - IRQ_TYPE_EDGE_BOTH
> - - gpio-ranges: Interaction with the PINCTRL subsystem, it also specifies the
> - gpio base and count, should be in the format of numeric-gpio-range as
> - specified in the gpio.txt file.
> -
> -Example:
> -
> -gpio0: gpio@0 {
> - compatible = "oxsemi,ox810se-gpio";
> - reg = <0x000000 0x100000>;
> - interrupts = <21>;
> - #gpio-cells = <2>;
> - gpio-controller;
> - interrupt-controller;
> - #interrupt-cells = <2>;
> - gpio-ranges = <&pinctrl 0 0 32>;
> -};
> -
> -keys {
> - ...
> -
> - button-esc {
> - label = "ESC";
> - linux,code = <1>;
> - gpios = <&gpio0 12 0>;
> - };
> -};
>
> --
> 2.34.1
>
Acked-by: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx>
