Re: [PATCH v6 2/5] regulator: max77541: Add ADI MAX77541/MAX77540 Regulator Support

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Tue, Mar 07, 2023 at 02:28:12PM +0300, Okan Sahin wrote:
> Regulator driver for both MAX77541 and MAX77540.
> The MAX77541 is a high-efficiency step-down converter
> with two 3A switching phases for single-cell Li+ battery
> and 5VDC systems.
> 
> The MAX77540 is a high-efficiency step-down converter
> with two 3A switching phases.

Reviewed-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>

But see below.

> Signed-off-by: Okan Sahin <okan.sahin@xxxxxxxxxx>
> ---
>  drivers/regulator/Kconfig              |   9 ++
>  drivers/regulator/Makefile             |   1 +
>  drivers/regulator/max77541-regulator.c | 153 +++++++++++++++++++++++++
>  3 files changed, 163 insertions(+)
>  create mode 100644 drivers/regulator/max77541-regulator.c
> 
> diff --git a/drivers/regulator/Kconfig b/drivers/regulator/Kconfig
> index aae28d0a489c..f0418274c083 100644
> --- a/drivers/regulator/Kconfig
> +++ b/drivers/regulator/Kconfig
> @@ -556,6 +556,15 @@ config REGULATOR_MAX597X
>  	  The MAX5970/5978 is a smart switch with no output regulation, but
>  	  fault protection and voltage and current monitoring capabilities.
>  
> +config REGULATOR_MAX77541
> +	tristate "Analog Devices MAX77541/77540 Regulator"
> +	depends on MFD_MAX77541
> +	help
> +	  This driver controls a Analog Devices MAX77541/77540 regulators
> +	  via I2C bus. Both MAX77540 and MAX77541 are dual-phase
> +	  high-efficiency buck converter. Say Y here to
> +	  enable the regulator driver.

Maybe adding what would be the module name if M is chosen?

>  config REGULATOR_MAX77620
>  	tristate "Maxim 77620/MAX20024 voltage regulator"
>  	depends on MFD_MAX77620 || COMPILE_TEST
> diff --git a/drivers/regulator/Makefile b/drivers/regulator/Makefile
> index ee383d8fc835..1c852f3140a3 100644
> --- a/drivers/regulator/Makefile
> +++ b/drivers/regulator/Makefile
> @@ -68,6 +68,7 @@ obj-$(CONFIG_REGULATOR_LTC3676) += ltc3676.o
>  obj-$(CONFIG_REGULATOR_MAX14577) += max14577-regulator.o
>  obj-$(CONFIG_REGULATOR_MAX1586) += max1586.o
>  obj-$(CONFIG_REGULATOR_MAX597X) += max597x-regulator.o
> +obj-$(CONFIG_REGULATOR_MAX77541) += max77541-regulator.o
>  obj-$(CONFIG_REGULATOR_MAX77620) += max77620-regulator.o
>  obj-$(CONFIG_REGULATOR_MAX77650) += max77650-regulator.o
>  obj-$(CONFIG_REGULATOR_MAX8649)	+= max8649.o
> diff --git a/drivers/regulator/max77541-regulator.c b/drivers/regulator/max77541-regulator.c
> new file mode 100644
> index 000000000000..f99caf3f3990
> --- /dev/null
> +++ b/drivers/regulator/max77541-regulator.c
> @@ -0,0 +1,153 @@
> +// SPDX-License-Identifier: GPL-2.0-or-later
> +/*
> + * Copyright (c) 2022 Analog Devices, Inc.
> + * ADI Regulator driver for the MAX77540 and MAX77541
> + */

I believe Mark asked to have this C++ comment style as well.

// Copyright (c) 2022 Analog Devices, Inc.
// ADI Regulator driver for the MAX77540 and MAX77541

> +#include <linux/mfd/max77541.h>
> +#include <linux/mod_devicetable.h>
> +#include <linux/platform_device.h>
> +#include <linux/regmap.h>
> +#include <linux/regulator/driver.h>
> +
> +static const struct regulator_ops max77541_buck_ops = {
> +	.enable			= regulator_enable_regmap,
> +	.disable		= regulator_disable_regmap,
> +	.is_enabled		= regulator_is_enabled_regmap,
> +	.list_voltage		= regulator_list_voltage_pickable_linear_range,
> +	.get_voltage_sel	= regulator_get_voltage_sel_pickable_regmap,
> +	.set_voltage_sel	= regulator_set_voltage_sel_pickable_regmap,
> +};
> +
> +static const struct linear_range max77540_buck_ranges[] = {
> +	/* Ranges when VOLT_SEL bits are 0x00 */
> +	REGULATOR_LINEAR_RANGE(500000, 0x00, 0x8B, 5000),
> +	REGULATOR_LINEAR_RANGE(1200000, 0x8C, 0xFF, 0),
> +	/* Ranges when VOLT_SEL bits are 0x40 */
> +	REGULATOR_LINEAR_RANGE(1200000, 0x00, 0x8B, 10000),
> +	REGULATOR_LINEAR_RANGE(2400000, 0x8C, 0xFF, 0),
> +	/* Ranges when VOLT_SEL bits are  0x80 */
> +	REGULATOR_LINEAR_RANGE(2000000, 0x00, 0x9F, 20000),
> +	REGULATOR_LINEAR_RANGE(5200000, 0xA0, 0xFF, 0),
> +};
> +
> +static const struct linear_range max77541_buck_ranges[] = {
> +	/* Ranges when VOLT_SEL bits are 0x00 */
> +	REGULATOR_LINEAR_RANGE(300000, 0x00, 0xB3, 5000),
> +	REGULATOR_LINEAR_RANGE(1200000, 0xB4, 0xFF, 0),
> +	/* Ranges when VOLT_SEL bits are 0x40 */
> +	REGULATOR_LINEAR_RANGE(1200000, 0x00, 0x8B, 10000),
> +	REGULATOR_LINEAR_RANGE(2400000, 0x8C, 0xFF, 0),
> +	/* Ranges when VOLT_SEL bits are  0x80 */
> +	REGULATOR_LINEAR_RANGE(2000000, 0x00, 0x9F, 20000),
> +	REGULATOR_LINEAR_RANGE(5200000, 0xA0, 0xFF, 0),
> +};
> +
> +static const unsigned int max77541_buck_volt_range_sel[] = {
> +	0x00, 0x00, 0x40, 0x40, 0x80, 0x80,
> +};
> +
> +enum max77541_regulators {
> +	MAX77541_BUCK1 = 1,
> +	MAX77541_BUCK2,
> +};
> +
> +#define MAX77540_BUCK(_id, _ops)					\
> +	{	.id = MAX77541_BUCK ## _id,				\
> +		.name = "buck"#_id,					\
> +		.of_match = "buck"#_id,					\
> +		.regulators_node = "regulators",			\
> +		.enable_reg = MAX77541_REG_EN_CTRL,			\
> +		.enable_mask = MAX77541_BIT_M ## _id ## _EN,		\
> +		.ops = &(_ops),						\
> +		.type = REGULATOR_VOLTAGE,				\
> +		.linear_ranges = max77540_buck_ranges,			\
> +		.n_linear_ranges = ARRAY_SIZE(max77540_buck_ranges),	\
> +		.vsel_reg = MAX77541_REG_M ## _id ## _VOUT,		\
> +		.vsel_mask = MAX77541_BITS_MX_VOUT,			\
> +		.vsel_range_reg = MAX77541_REG_M ## _id ## _CFG1,	\
> +		.vsel_range_mask = MAX77541_BITS_MX_CFG1_RNG,		\
> +		.linear_range_selectors = max77541_buck_volt_range_sel, \
> +		.owner = THIS_MODULE,					\
> +	}
> +
> +#define MAX77541_BUCK(_id, _ops)					\
> +	{	.id = MAX77541_BUCK ## _id,				\
> +		.name = "buck"#_id,					\
> +		.of_match = "buck"#_id,					\
> +		.regulators_node = "regulators",			\
> +		.enable_reg = MAX77541_REG_EN_CTRL,			\
> +		.enable_mask = MAX77541_BIT_M ## _id ## _EN,		\
> +		.ops = &(_ops),						\
> +		.type = REGULATOR_VOLTAGE,				\
> +		.linear_ranges = max77541_buck_ranges,			\
> +		.n_linear_ranges = ARRAY_SIZE(max77541_buck_ranges),	\
> +		.vsel_reg = MAX77541_REG_M ## _id ## _VOUT,		\
> +		.vsel_mask = MAX77541_BITS_MX_VOUT,			\
> +		.vsel_range_reg = MAX77541_REG_M ## _id ## _CFG1,	\
> +		.vsel_range_mask = MAX77541_BITS_MX_CFG1_RNG,		\
> +		.linear_range_selectors = max77541_buck_volt_range_sel, \
> +		.owner = THIS_MODULE,					\
> +	}
> +
> +static const struct regulator_desc max77540_regulators_desc[] = {
> +	MAX77540_BUCK(1, max77541_buck_ops),
> +	MAX77540_BUCK(2, max77541_buck_ops),
> +};
> +
> +static const struct regulator_desc max77541_regulators_desc[] = {
> +	MAX77541_BUCK(1, max77541_buck_ops),
> +	MAX77541_BUCK(2, max77541_buck_ops),
> +};
> +
> +static int max77541_regulator_probe(struct platform_device *pdev)
> +{
> +	struct regulator_config config = {};
> +	const struct regulator_desc *desc;
> +	struct device *dev = &pdev->dev;
> +	struct regulator_dev *rdev;
> +	struct max77541 *max77541 = dev_get_drvdata(dev->parent);
> +	unsigned int i;
> +
> +	config.dev = dev->parent;
> +
> +	switch (max77541->chip->id) {
> +	case MAX77540:
> +		desc = max77540_regulators_desc;
> +		break;
> +	case MAX77541:
> +		desc = max77541_regulators_desc;
> +		break;
> +	default:
> +		return -EINVAL;
> +	}
> +
> +	for (i = 0; i < MAX77541_MAX_REGULATORS; i++) {
> +		rdev = devm_regulator_register(dev, &desc[i], &config);
> +		if (IS_ERR(rdev))
> +			return dev_err_probe(dev, PTR_ERR(rdev),
> +					     "Failed to register regulator\n");
> +	}
> +
> +	return 0;
> +}
> +
> +static const struct platform_device_id max77541_regulator_platform_id[] = {
> +	{ "max77540-regulator" },
> +	{ "max77541-regulator" },
> +	{ }
> +};
> +MODULE_DEVICE_TABLE(platform, max77541_regulator_platform_id);
> +
> +static struct platform_driver max77541_regulator_driver = {
> +	.driver = {
> +		.name = "max77541-regulator",
> +	},
> +	.probe = max77541_regulator_probe,
> +	.id_table = max77541_regulator_platform_id,
> +};
> +module_platform_driver(max77541_regulator_driver);
> +
> +MODULE_AUTHOR("Okan Sahin <Okan.Sahin@xxxxxxxxxx>");
> +MODULE_DESCRIPTION("MAX77540/MAX77541 regulator driver");
> +MODULE_LICENSE("GPL");
> -- 
> 2.30.2
> 

-- 
With Best Regards,
Andy Shevchenko





[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux