On 05/11/14 13:57, Ivan T. Ivanov wrote:
>
> On Wed, 2014-11-05 at 13:09 +0000, Jonathan Cameron wrote:
>> On 03/11/14 15:24, Ivan T. Ivanov wrote:
>>> From: Stanimir Varbanov <svarbanov@xxxxxxxxxx>
>>>
>>> The voltage ADC is peripheral of Qualcomm SPMI PMIC chips. It has
>>> 15 bits resolution and register space inside PMIC accessible across
>>> SPMI bus.
>>>
>>> The vadc driver registers itself through IIO interface.
>>>
>>> Signed-off-by: Stanimir Varbanov <svarbanov@xxxxxxxxxx>
>>> Signed-off-by: Ivan T. Ivanov <iivanov@xxxxxxxxxx>
>> Hi Ivan,
>>
>> Couple of utterly tiny bits inline. The biggest one is that
>> you store some info about the calibration that you never actually
>> use... Left over from some debugging perhaps?
>>
>> Jonathan
>
> <snip>
>
>>> +
>>> +/*
>>> + * VADC_CALIB_ABSOLUTE: uses the 625mV and 1.25V as reference channels.
>>> + * VADC_CALIB_RATIOMETRIC: uses the reference voltage (1.8V) and GND for
>>> + * calibration.
>>> + */
>>> +enum vadc_calibration {
>>> + VADC_CALIB_ABSOLUTE = 0,
>>> + VADC_CALIB_RATIOMETRIC
>>> +};
>>> +
>>> +/**
>>> + * struct vadc_linear_graph - Represent ADC characteristics.
>>> + * @dy: numerator slope to calculate the gain.
>> As dy is always equal to vref-gnd you could drop it and use those
>> directly...
>>
>> Conversly you store vref or grnd and never use them...
>
> I am not sure I am following you. Please take a look in
> vadc_measure_ref_points() and vadc_calibrate().
Good point on grnd, but vref is set but never read anywhere that I can find..
>
>>
>>> + * @dx: denominator slope to calculate the gain.
>>> + * @vref: A/D word of the voltage reference used for the channel.
>>> + * @gnd: A/D word of the ground reference used for the channel.
>>> + *
>>> + * Each ADC device has different offset and gain parameters which are
>>> + * computed to calibrate the device.
>>> + */
>>> +struct vadc_linear_graph {
>>> + s32 dy;
>>> + s32 dx;
>>> + s32 vref;
>>> + s32 gnd;
>>> +};
>>> +
>>>
>
> Will address blank line comment.
>
> Regards,
> Ivan
> --
> To unsubscribe from this list: send the line "unsubscribe linux-iio" in
> the body of a message to majordomo@xxxxxxxxxxxxxxx
> More majordomo info at http://vger.kernel.org/majordomo-info.html
>
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
