On 22/09/22 12:59, Keerthy wrote: > The parent's input irq number is wrongly subtracted with 32 instead of > using the exact numbers in: > > https://software-dl.ti.com/tisci/esd/latest/5_soc_doc/j721s2/interrupt_cfg.html > > The GPIO interrupts are not working because of that. The toggling works > fine but interrupts are not firing. Fix the parent's input irq that > specifies the base for parent irq. > > Tested for MAIN_GPIO0_6 interrupt on the j721s2 EVM. > > Fixes: b8545f9d3a542 ("arm64: dts: ti: Add initial support for J721S2 SoC") > Signed-off-by: Keerthy <j-keerthy@xxxxxx> > --- > arch/arm64/boot/dts/ti/k3-j721s2-main.dtsi | 2 +- > arch/arm64/boot/dts/ti/k3-j721s2-mcu-wakeup.dtsi | 2 +- > 2 files changed, 2 insertions(+), 2 deletions(-) > > diff --git a/arch/arm64/boot/dts/ti/k3-j721s2-main.dtsi b/arch/arm64/boot/dts/ti/k3-j721s2-main.dtsi > index 34e7d577ae13..c89f28235812 100644 > --- a/arch/arm64/boot/dts/ti/k3-j721s2-main.dtsi > +++ b/arch/arm64/boot/dts/ti/k3-j721s2-main.dtsi > @@ -60,7 +60,7 @@ > #interrupt-cells = <1>; > ti,sci = <&sms>; > ti,sci-dev-id = <148>; > - ti,interrupt-ranges = <8 360 56>; > + ti,interrupt-ranges = <8 392 56>; > }; > > main_pmx0: pinctrl@11c000 { > diff --git a/arch/arm64/boot/dts/ti/k3-j721s2-mcu-wakeup.dtsi b/arch/arm64/boot/dts/ti/k3-j721s2-mcu-wakeup.dtsi > index 4d1bfabd1313..f0644851602c 100644 > --- a/arch/arm64/boot/dts/ti/k3-j721s2-mcu-wakeup.dtsi > +++ b/arch/arm64/boot/dts/ti/k3-j721s2-mcu-wakeup.dtsi > @@ -65,7 +65,7 @@ > #interrupt-cells = <1>; > ti,sci = <&sms>; > ti,sci-dev-id = <125>; > - ti,interrupt-ranges = <16 928 16>; > + ti,interrupt-ranges = <16 960 16>; Reviewed-by: Vaishnav Achath <vaishnav.a@xxxxxx> > }; > > mcu_conf: syscon@40f00000 { -- Regards, Vaishnav
