On Wed, Nov 02, 2022 at 02:11:57PM +0100, Marcel Ziswiler wrote: > From: Marcel Ziswiler <marcel.ziswiler@xxxxxxxxxxx> > > > This series is an assortment of USB dual-role specific commits as > follows: > > Improvement of pinctrl for vbus-supplies: > As we are using two fixed regulators for Verdin USB_1_EN (SODIMM 155) > and Verdin USB_2_EN (SODIMM 185), those should be muxed as GPIOs rather > than OTG_PWR. > > Removal of USB_2 over-current detection disabling: > The disable-over-current property is only applicable for the > ci-hdrc-usb2 and dwc2 drivers while the i.MX 8M Plus integrates dwc3 > IP. Therefore remove this property which does not really serve any > purpose here. > > Addition of USB_1 over-current detection: > Add Verdin USB_1 over-current detection functionality via Verdin > USB_1_OC# (SODIMM 157) being active-low and removing its previous > gpio_hog3 mapping. > > Disabling of USB port power controls: > Disable port power control on Verdin USB_1/2 as we use regular > fixed-regulators with Verdin USB_1/2_EN as enable GPIOs. > > Addition of GPIO USB-B connector: > Add GPIO USB-B connector (gpio-usb-b-connector) functionality using > Verdin USB_1_ID. > > Marking USB_2 as permanently attached: > As both Dahlia and the Verdin Development Board have on-carrier > permanently attached USB hubs mark Verdin USB_2 as such. > > Note: > Currently, I am still seeing a rare race condition of sorts when booting > the system with Verdin USB_1 as a host port with a USB memory stick > plugged in. This exact patch series applied on top of NXP's latest > downstream 5.15.52_2.1.0 release (together with backporting a few more > dwc3-specific patches) actually makes this same use case work very > reliably. However, NXP also keeps further downstream-only patches which > I plan to further investigate and hopefully upstream a proper fix for > soon. Thanks for the noting! > > > Marcel Ziswiler (6): > arm64: dts: verdin-imx8mp: improve pinctrl for vbus-supplies > arm64: dts: verdin-imx8mp: remove usb_2 over-current detection > disabling > arm64: dts: verdin-imx8mp: add usb_1 over-current detection > arm64: dts: verdin-imx8mp: disable usb port power control > arm64: dts: verdin-imx8mp: add gpio usb-b connector > arm64: dts: verdin-imx8mp: dahlia: mark usb_2 permanently attached Applied all, thanks!
