Add Device Tree Binding doc for configuring Lattice ECP5 FPGA over Slave SPI sysCONFIG interface. Signed-off-by: Ivan Bornyakov <i.bornyakov@xxxxxxxxxxx> Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx> --- .../bindings/fpga/lattice,sysconfig.yaml | 81 +++++++++++++++++++ 1 file changed, 81 insertions(+) create mode 100644 Documentation/devicetree/bindings/fpga/lattice,sysconfig.yaml diff --git a/Documentation/devicetree/bindings/fpga/lattice,sysconfig.yaml b/Documentation/devicetree/bindings/fpga/lattice,sysconfig.yaml new file mode 100644 index 000000000000..4fb05eb84e2a --- /dev/null +++ b/Documentation/devicetree/bindings/fpga/lattice,sysconfig.yaml @@ -0,0 +1,81 @@ +# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) +%YAML 1.2 +--- +$id: http://devicetree.org/schemas/fpga/lattice,sysconfig.yaml# +$schema: http://devicetree.org/meta-schemas/core.yaml# + +title: Lattice Slave SPI sysCONFIG FPGA manager + +maintainers: + - Ivan Bornyakov <i.bornyakov@xxxxxxxxxxx> + +description: | + Lattice sysCONFIG port, which is used for FPGA configuration, among others, + have Slave Serial Peripheral Interface. Only full reconfiguration is + supported. + + Programming of ECP5 is done by writing uncompressed bitstream image in .bit + format into FPGA's SRAM configuration memory. + +properties: + compatible: + enum: + - lattice,sysconfig-ecp5 + + reg: + maxItems: 1 + + program-gpios: + description: + A GPIO line connected to PROGRAMN (active low) pin of the device. + Initiates configuration sequence. + maxItems: 1 + + init-gpios: + description: + A GPIO line connected to INITN (active low) pin of the device. + Indicates that the FPGA is ready to be configured. + maxItems: 1 + + done-gpios: + description: + A GPIO line connected to DONE (active high) pin of the device. + Indicates that the configuration sequence is complete. + maxItems: 1 + +required: + - compatible + - reg + +allOf: + - $ref: /schemas/spi/spi-peripheral-props.yaml + + - if: + properties: + compatible: + contains: + const: lattice,sysconfig-ecp5 + then: + properties: + spi-max-frequency: + maximum: 60000000 + +unevaluatedProperties: false + +examples: + - | + #include <dt-bindings/gpio/gpio.h> + + spi { + #address-cells = <1>; + #size-cells = <0>; + + fpga-mgr@0 { + compatible = "lattice,sysconfig-ecp5"; + reg = <0>; + spi-max-frequency = <20000000>; + program-gpios = <&gpio3 4 GPIO_ACTIVE_LOW>; + init-gpios = <&gpio3 3 GPIO_ACTIVE_LOW>; + done-gpios = <&gpio3 2 GPIO_ACTIVE_HIGH>; + }; + }; -- 2.37.4
