On Tue, Oct 21, 2014 at 1:52 PM, Andreas Färber <afaerber@xxxxxxx> wrote: > Hi Olof and Sören, > > Am 18.10.2014 um 06:28 schrieb Olof Johansson: >> On Thu, Jul 24, 2014 at 4:00 PM, Andreas Färber <afaerber@xxxxxxx> wrote: >>> Hello, >>> >>> This patch series adds an initial device tree for the Parallella board. >>> UART, SD card, Ethernet are enabled. >>> Not yet enabled are HDMI, QSPI flash and 2x USB. >> >> Andreas (Olofsson) kindly sent me a board, and I added it to the boot >> farm today, it'll be included in boot reports from here on. > > Good to hear. > >> I did a test run with yesterday's -next It looks like networking isn't >> working there at the moment, clock related. Same happens with 3.17 and >> latest mainline, config multi_v7_defconfig: >> >> [WARN] [ 7.943648] macb e000b000.ethernet eth0: unable to generate >> target frequency: 125000000 Hz >> [WARN] [ 10.948681] macb e000b000.ethernet eth0: unable to generate >> target frequency: 125000000 Hz > > I am unable to reproduce this in my setup - at Linus' tip > c2661b806092d8ea2dccb7b02b65776555e0ee47 (v3.18-rc1-68-gc2661b8), make > oldconfig'ing my /proc/config.gz. > > Sören, in light of your explanations, should I be expecting problems > with 1GbE or with 100MbE? My board is connected to a 1GbE switch. My board might have old firmware/bitstream on it? It reports as: U-Boot 2012.10-00003-g792c31c (Jan 03 2014 - 12:24:08) -Olof -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html