On Tue, 11 Oct 2022 23:54:37 +0530, Rajat Khandelwal wrote: > The datasheet states that the slave address for the device is 0x20 > when the pins A0 and A1 are ground. The DT binding has been using > 0x10 as the value and I think it should be 0x20 as per datasheet. > > Let me know if I am wrong about this. > > Signed-off-by: Rajat Khandelwal <rajat.khandelwal@xxxxxxxxxxxxxxx> > --- > Documentation/devicetree/bindings/iio/dac/maxim,ds4424.yaml | 2 +- > 1 file changed, 1 insertion(+), 1 deletion(-) > My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check' on your patch (DT_CHECKER_FLAGS is new in v5.13): yamllint warnings/errors: dtschema/dtc warnings/errors: Documentation/devicetree/bindings/iio/dac/maxim,ds4424.example.dts:22.20-26.15: Warning (i2c_bus_reg): /example-0/i2c/dac@10: I2C bus unit address format error, expected "20" doc reference errors (make refcheckdocs): See https://patchwork.ozlabs.org/patch/ This check can fail if there are any dependencies. The base for a patch series is generally the most recent rc1. If you already ran 'make dt_binding_check' and didn't see the above error(s), then make sure 'yamllint' is installed and dt-schema is up to date: pip3 install dtschema --upgrade Please check and re-submit.
