There are no need to add additional simple-bus nodes just to populate
a single pwrseq device. Pull it up one level into /. While we are at it
also fix node name replacing underscore with dash.
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
---
arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts | 17 +++++------------
1 file changed, 5 insertions(+), 12 deletions(-)
diff --git a/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts b/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
index 5ff0d9a275cc..d6ecfd8addb7 100644
--- a/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
+++ b/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
@@ -15,18 +15,11 @@ chosen {
stdout-path = "serial0:115200n8";
};
- pwrseq {
- #address-cells = <1>;
- #size-cells = <1>;
- ranges;
- compatible = "simple-bus";
-
- sdcc4_pwrseq: sdcc4_pwrseq {
- pinctrl-names = "default";
- pinctrl-0 = <&wlan_default_gpios>;
- compatible = "mmc-pwrseq-simple";
- reset-gpios = <&pm8921_gpio 43 GPIO_ACTIVE_LOW>;
- };
+ sdcc4_pwrseq: pwrseq-sdcc4 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&wlan_default_gpios>;
+ compatible = "mmc-pwrseq-simple";
+ reset-gpios = <&pm8921_gpio 43 GPIO_ACTIVE_LOW>;
};
/* on board fixed 3.3v supply */
--
2.35.1
