On 23/09/2022 11:31, Krzysztof Kozlowski wrote: > On Thu, 22 Sep 2022 21:56:47 +0200, Krzysztof Kozlowski wrote: >> The existing SC7280 LPASS pin controller nodes use bias-bus-hold and >> input-enable, so allow them. Squash also blank lines for readability. >> >> Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx> >> --- >> .../bindings/pinctrl/qcom,sm8250-lpass-lpi-pinctrl.yaml | 6 ++---- >> 1 file changed, 2 insertions(+), 4 deletions(-) >> > > Running 'make dtbs_check' with the schema in this patch gives the > following warnings. Consider if they are expected or the schema is > incorrect. These may not be new warnings. > > Note that it is not yet a requirement to have 0 warnings for dtbs_check. > This will change in the future. > > Full log is available here: https://patchwork.ozlabs.org/patch/1681325 > > > pinctrl@33c0000: 'dmic01-active-pins', 'dmic01-sleep-pins', 'rx_swr-active-pins', 'tx_swr-active-pins', 'tx_swr-sleep-pins', 'wsa-swr-active-pins', 'wsa-swr-sleep-pins' do not match any of the regexes: '-state$', 'pinctrl-[0-9]+' This is being fixed in next DTS patches. I'll reorganize them if there is going to be a resubmit. Best regards, Krzysztof
