From: Aswath Govindraju <a-govindraju@xxxxxx> Configure first lane to PCIe, the second lane to USB and the last two lanes to eDP. Also, add sub-nodes to SERDES0 DT node to represent SERDES0 is connected to PCIe. Cc: Vignesh Raghavendra <vigneshr@xxxxxx> Cc: Nishanth Menon <nm@xxxxxx> Acked-by: Matt Ranostay <mranostay@xxxxxx> Signed-off-by: Aswath Govindraju <a-govindraju@xxxxxx> --- .../dts/ti/k3-j721s2-common-proc-board.dts | 22 +++++++++++++++++++ 1 file changed, 22 insertions(+) diff --git a/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts b/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts index b210cc07c539..791f235bd95f 100644 --- a/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts +++ b/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts @@ -9,6 +9,9 @@ #include "k3-j721s2-som-p0.dtsi" #include <dt-bindings/net/ti-dp83867.h> +#include <dt-bindings/phy/phy-cadence.h> +#include <dt-bindings/phy/phy.h> +#include <dt-bindings/mux/ti-serdes.h> / { compatible = "ti,j721s2-evm", "ti,j721s2"; @@ -350,6 +353,25 @@ &cpsw_port1 { phy-handle = <&phy0>; }; +&serdes_ln_ctrl { + idle-states = <J721S2_SERDES0_LANE0_PCIE1_LANE0>, <J721S2_SERDES0_LANE1_USB>, + <J721S2_SERDES0_LANE2_EDP_LANE2>, <J721S2_SERDES0_LANE3_EDP_LANE3>; +}; + +&serdes_refclk { + clock-frequency = <100000000>; +}; + +&serdes0 { + serdes0_pcie_link: phy@0 { + reg = <0>; + cdns,num-lanes = <1>; + #phy-cells = <0>; + cdns,phy-type = <PHY_TYPE_PCIE>; + resets = <&serdes_wiz0 1>; + }; +}; + &mcu_mcan0 { pinctrl-names = "default"; pinctrl-0 = <&mcu_mcan0_pins_default>; -- 2.37.2