> -----Original Message-----
> From: Shawn Guo <shawnguo@xxxxxxxxxx>
> Sent: Monday, September 12, 2022 3:17 AM
> To: Shenwei Wang <shenwei.wang@xxxxxxx>
> Cc: Rob Herring <robh+dt@xxxxxxxxxx>; Krzysztof Kozlowski
> <krzysztof.kozlowski+dt@xxxxxxxxxx>; Sascha Hauer <s.hauer@xxxxxxxxxxxxxx>;
> Pengutronix Kernel Team <kernel@xxxxxxxxxxxxxx>; Peng Fan
> <peng.fan@xxxxxxx>; devicetree@xxxxxxxxxxxxxxx; linux-arm-
> kernel@xxxxxxxxxxxxxxxxxxx; imx@xxxxxxxxxxxxxxx; dl-linux-imx <linux-
> imx@xxxxxxx>
> > > > +
> > > > + reg_fec1_sel: regulator-1 {
> > > > + compatible = "regulator-fixed";
> > > > + regulator-name = "fec1_supply";
> > > > + regulator-min-microvolt = <3300000>;
> > > > + regulator-max-microvolt = <3300000>;
> > > > + gpio = <&pca6416_1 11 GPIO_ACTIVE_HIGH>;
> > >
> > > Missing enable-active-high?
> >
> > No. Enabling this regulator to select the fec1 interface instead of usdhc2.
> Pulling this GPIO pin to low is to use FEC1 interface.
>
> Then the polarity cell should be GPIO_ACTIVE_LOW rather than
> GPIO_ACTIVE_HIGH?
>
That doesn't matter since any GPIO phandle flags are ignored in the node of "regulator-fixed". The final flag is only determined by the property of "enable-active-high". If there is a "enable-active-high", the GPIO line works as active high. If no such a property, it works as active low by default. Right?
Regards,
Shenwei
> Shawn
