On 12/08/2022 19:05, ChiYuan Huang wrote:
>> It's the same usage like as TI charger.
>>>>
>>>> For charger driver, does it mean legacy IRQ handler is more preferred?
>>>
>>> Who is the consumer of these interrupts? Can you show the DTS with the
>>> interrupt consumer?
>>>
> Sorry, I forget to reply this question.
> Some battery driver may need to know the 'full', 'recharge' , 'ieoc' status.
> The usage will be like as below
>
> battery {
> interrupts-extended = <&rt9471_chg 2 0>, <&rt9471_chg 3 0>, &(rt9471_chg 5 0>;
> interrupt-names = "chg-done", "chg-recharge", "chg-ieoc";
> };
>
> Some gauge HW needs this information to enhance the battery capacity accuracy.
Other supply stack pieces do it via supplies (supplied to/from in
include/linux/power_supply.h) and reporting power_supply_changed().
With such explanation, your device is an interrupt source, but it is not
an interrupt controller. If your device is interrupt controller, it
means someone routes the interrupt line to your device. Physical line.
Best regards,
Krzysztof
