Hi,
On 02/10/2014 at 13:19:45 +0200, Alexander Stein wrote :
> Add the missing CAN devices node including their pin muxing and clocks.
>
> Signed-off-by: Alexander Stein <alexander.stein@xxxxxxxxxxxxxxxxxxxxx>
> ---
> Changes in v2:
> * Adjusted pinmux comment
>
> arch/arm/boot/dts/at91sam9x5.dtsi | 48 +++++++++++++++++++++++++++++++++++++++
> 1 file changed, 48 insertions(+)
>
> diff --git a/arch/arm/boot/dts/at91sam9x5.dtsi b/arch/arm/boot/dts/at91sam9x5.dtsi
> index e1a5c70..e3f11f2 100644
> --- a/arch/arm/boot/dts/at91sam9x5.dtsi
> +++ b/arch/arm/boot/dts/at91sam9x5.dtsi
> @@ -763,6 +795,22 @@
> };
> };
>
> + can0 {
> + pinctrl_can0_rx_tx: can0_rx_tx {
> + atmel,pins =
> + <AT91_PIOA 9 AT91_PERIPH_B AT91_PINCTRL_NONE /* CANRX, conflicts with DRXD */
> + AT91_PIOA 10 AT91_PERIPH_B AT91_PINCTRL_NONE>; /* CANTX, conflicts with DTXD */
Last nitpick, could you make that be CANRX0 and CANTX0 ?
> + };
> + };
> +
> + can1 {
> + pinctrl_can1_rx_tx: can1_rx_tx {
> + atmel,pins =
> + <AT91_PIOA 6 AT91_PERIPH_B AT91_PINCTRL_NONE /* CANRX, conflicts with RXD1 */
> + AT91_PIOA 5 AT91_PERIPH_B AT91_PINCTRL_NONE>; /* CANTX, conflicts with TXD1 */
And CANRX1, CANTX1 here so that it is the same as the datasheet.
Then you can add my acked-by.
Thanks !
> + };
> + };
> +
> pioA: gpio@fffff400 {
> compatible = "atmel,at91sam9x5-gpio", "atmel,at91rm9200-gpio";
> reg = <0xfffff400 0x200>;
> --
> 2.0.4
>
>
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel@xxxxxxxxxxxxxxxxxxx
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
--
Alexandre Belloni, Free Electrons
Embedded Linux, Kernel and Android engineering
http://free-electrons.com
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
