Rename the dt nodes shown in the sff,sfp.yaml examples so that they are
generic and not really tied to a specific platform.
Signed-off-by: Ioana Ciornei <ioana.ciornei@xxxxxxx>
---
Changes in v2:
- new patch
.../devicetree/bindings/net/sff,sfp.yaml | 18 +++++++++---------
1 file changed, 9 insertions(+), 9 deletions(-)
diff --git a/Documentation/devicetree/bindings/net/sff,sfp.yaml b/Documentation/devicetree/bindings/net/sff,sfp.yaml
index 86f3ed2546d9..e309395ea7e7 100644
--- a/Documentation/devicetree/bindings/net/sff,sfp.yaml
+++ b/Documentation/devicetree/bindings/net/sff,sfp.yaml
@@ -90,7 +90,7 @@ examples:
- | # Direct serdes to SFP connection
#include <dt-bindings/gpio/gpio.h>
- sfp_eth3: sfp-eth3 {
+ sfp1: sfp {
compatible = "sff,sfp";
i2c-bus = <&sfp_1g_i2c>;
los-gpios = <&cpm_gpio2 22 GPIO_ACTIVE_HIGH>;
@@ -102,19 +102,19 @@ examples:
tx-fault-gpios = <&cpm_gpio2 19 GPIO_ACTIVE_HIGH>;
};
- cps_emac3 {
+ ethernet {
phy-names = "comphy";
phys = <&cps_comphy5 0>;
- sfp = <&sfp_eth3>;
+ sfp = <&sfp1>;
};
- | # Serdes to PHY to SFP connection
#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/interrupt-controller/arm-gic.h>
- sfp_eth0: sfp-eth0 {
+ sfp2: sfp {
compatible = "sff,sfp";
- i2c-bus = <&sfpp0_i2c>;
+ i2c-bus = <&sfp_i2c>;
los-gpios = <&cps_gpio1 28 GPIO_ACTIVE_HIGH>;
mod-def0-gpios = <&cps_gpio1 27 GPIO_ACTIVE_LOW>;
pinctrl-names = "default";
@@ -127,17 +127,17 @@ examples:
#address-cells = <1>;
#size-cells = <0>;
- p0_phy: ethernet-phy@0 {
+ phy: ethernet-phy@0 {
compatible = "ethernet-phy-ieee802.3-c45";
pinctrl-names = "default";
pinctrl-0 = <&cpm_phy0_pins &cps_phy0_pins>;
reg = <0>;
interrupt = <&cpm_gpio2 18 IRQ_TYPE_EDGE_FALLING>;
- sfp = <&sfp_eth0>;
+ sfp = <&sfp2>;
};
};
- cpm_eth0 {
- phy = <&p0_phy>;
+ ethernet {
+ phy = <&phy>;
phy-mode = "10gbase-kr";
};
--
2.17.1
