[PATCH 5/8] dt_bindings: rs485: Correct delay values

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



From: Lino Sanfilippo <l.sanfilippo@xxxxxxxxxx>

The maximum allowed delay for RTS before and RTS after send is 100 ms.
Adjust the documentation accordingly.

Signed-off-by: Lino Sanfilippo <l.sanfilippo@xxxxxxxxxx>
---
 Documentation/devicetree/bindings/serial/rs485.yaml | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/Documentation/devicetree/bindings/serial/rs485.yaml b/Documentation/devicetree/bindings/serial/rs485.yaml
index f2c9c9fe6aa7..90a1bab40f05 100644
--- a/Documentation/devicetree/bindings/serial/rs485.yaml
+++ b/Documentation/devicetree/bindings/serial/rs485.yaml
@@ -22,12 +22,12 @@ properties:
         - description: Delay between rts signal and beginning of data sent in
             milliseconds. It corresponds to the delay before sending data.
           default: 0
-          maximum: 1000
+          maximum: 100
         - description: Delay between end of data sent and rts signal in milliseconds.
             It corresponds to the delay after sending data and actual release
             of the line.
           default: 0
-          maximum: 1000
+          maximum: 100
 
   rs485-rts-active-low:
     description: drive RTS low when sending (default is high).
-- 
2.36.1


[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux