Re: [PATCH 10/10] pinctrl: Add AXP192 pin control driver

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Am 15. Juni 2022 15:44:04 OEZ schrieb Linus Walleij <linus.walleij@xxxxxxxxxx>:
>On Fri, Jun 3, 2022 at 3:56 PM Aidan MacDonald
><aidanmacdonald.0x0@xxxxxxxxx> wrote:
>
>> The AXP192 PMIC's GPIO registers are much different from the GPIO
>> registers of the AXP20x and AXP813 PMICs supported by the existing
>> pinctrl-axp209 driver. It makes more sense to add a new driver for
>> the AXP192, rather than add support in the existing axp20x driver.
>>
>> The pinctrl-axp192 driver is considerably more flexible in terms of
>> register layout and should be able to support other X-Powers PMICs.
>> Interrupts and pull down resistor configuration are supported too.
>>
>> Signed-off-by: Aidan MacDonald <aidanmacdonald.0x0@xxxxxxxxx>
>
>Looks good to me (TM) but I'd like Michael Walle to take a look
>to check if this is one of those drivers that could make use of
>gpio-regmap.c CONFIG_GPIO_REGMAP to make it even
>simpler.
>
>Yours,
>Linus Walleij

FWIW, I can look at it at the end of next week. I'm on vacation.

-michael 




[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux