Re: [PATCH 10/10] pinctrl: Add AXP192 pin control driver

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Fri, Jun 3, 2022 at 3:56 PM Aidan MacDonald
<aidanmacdonald.0x0@xxxxxxxxx> wrote:

> The AXP192 PMIC's GPIO registers are much different from the GPIO
> registers of the AXP20x and AXP813 PMICs supported by the existing
> pinctrl-axp209 driver. It makes more sense to add a new driver for
> the AXP192, rather than add support in the existing axp20x driver.
>
> The pinctrl-axp192 driver is considerably more flexible in terms of
> register layout and should be able to support other X-Powers PMICs.
> Interrupts and pull down resistor configuration are supported too.
>
> Signed-off-by: Aidan MacDonald <aidanmacdonald.0x0@xxxxxxxxx>

Looks good to me (TM) but I'd like Michael Walle to take a look
to check if this is one of those drivers that could make use of
gpio-regmap.c CONFIG_GPIO_REGMAP to make it even
simpler.

Yours,
Linus Walleij



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux