On Mon, May 9, 2022 at 2:48 AM Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx> wrote: > > On 08/05/2022 19:04, Peter Geis wrote: > > On Sun, May 8, 2022 at 8:12 AM Frank Wunderlich <frank-w@xxxxxxxxxxxxxxx> wrote: > >>> > >>> I think the issue is more for the description itself. > >>> > >>> Devicetree is only meant to describe the hardware and does in general don't > >>> care how any firmware (Linux-kernel, *BSD, etc) handles it. So going with > >>> "the kernel does it this way" is not a valid reason for a binding change ;-) . > > Exactly. The argument in commit msg was not matching the change, because > driver implementation should not be (mostly) a reason for such changes. > > >>> > >>> Instead in general want to reason that there are boards without this reset > >>> facility and thus make it optional for those. > >> > >> if only the wording is the problem i try to rephrase it from hardware PoV. > >> > >> maybe something like this? > >> > >> https://github.com/frank-w/BPI-R2-4.14/commits/5.18-mt7531-mainline2/Documentation/devicetree/bindings/net/dsa/mediatek%2Cmt7530.yaml > > Looks ok. > > >> > >> Another way is maybe increasing the delay after the reset (to give more time all > >> come up again), but imho it is no good idea resetting the gmac/mdio-bus from the > >> child device. > >> > >> have not looked into the gmac driver if this always does the initial reset to > >> have a "clean state". In this initial reset the switch will be resetted too > >> and does not need an additional one which needs the gmac/mdio initialization > >> to be done again. > > > > For clarification, the reset gpio line is purely to reset the phy. > > If having the switch driver own the reset gpio instead of the gmac > > breaks initialization that means there's a bug in the gmac driver > > handling phy init. > > In testing I've seen issues moving the reset line to the mdio node > > with other phys and the stmmac gmac driver, so I do believe this is > > the case. > > Yes, this seems reasonable, although Frank mentioned that reset is > shared with gmac, so it resets some part of it as well? No, the gpio-reset line is purely to reset the phy. The stmmac gmac driver handles it because it seems initialization failures occur if it's handled by the mdio drivers. I suspect this is due to a difference between when the driver initializes the phy vs when the driver triggers the reset. They had tried to attach the gpio binding to both the gmac node and the mdio node at the same time when only one can own it. Having it owned by the switch driver on the mdio node leads to the same initialization failures we see in other mdio drivers. > > > > > Best regards, > Krzysztof
