Re: [PATCH v3 5/6] dt-bindings: net: dsa: make reset optional and add rgmii-mode to mt7531

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Am 7. Mai 2022 22:01:22 MESZ schrieb Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>:
>On 07/05/2022 19:04, Frank Wunderlich wrote:
>> From: Frank Wunderlich <frank-w@xxxxxxxxxxxxxxx>
>> 
>> Make reset optional as driver already supports it, 
>
>I do not see the connection between hardware needing or not needing a
>reset GPIO and a driver supporting it or not... What does it mean?

My board has a shared gpio-reset between gmac and switch, so both will resetted if it is asserted. Currently it is set to the gmac and is aquired exclusive. Adding it to switch results in 2 problems:

- due to exclusive and already mapped to gmac, switch driver exits as it cannot get the reset-gpio again.
- if i drop the reset from gmac and add to switch, it resets the gmac and this takes too long for switch to get up. Of course i can increase the wait time after reset,but dropping reset here was the easier way.

Using reset only on gmac side brings the switch up.

>> allow port 5 as
>> cpu-port 
>
>How do you allow it here?

Argh, seems i accidentally removed this part and have not recognized while checking :(

It should only change description of reg for ports to:

"Port address described must be 5 or 6 for CPU port and from 0 to 5 for user ports."

regards Frank




[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux