From: Marcel Ziswiler <marcel.ziswiler@xxxxxxxxxxx>
This is a general update of the Colibri iMX6ULL device tree files.
The Toradex Colibri family is composed of a SoM that can be plugged on
various carrier boards, with carrier boards allowing multiple optional
accessories (e.g. display, camera, ...).
The device tree sources are structured into a SoM dtsi and a carrier dts
which then includes the SoM dtsi. The SoM dtsi defines and enables the
functionality self-contained on the SoM and prepares for the
functionality provided by the carrier HW or accessories so that the
carrier dts then can enable or amend nodes provided. Accessories are
enabled in overlays depending on HW configuration.
Please find the following colibri-imx6ull device trees improvements:
- MMC/SD
The original Colibri specification only defined 3.3 volt TTL signaling
and relied on external on-carrier pull-ups for the SD_DATA[0..3] lines.
The latest carrier boards like Iris V2 on the other hand are now UHS-I
compliant by leaving such external on-carrier pull-ups away relying on
module- or even SoC-level ones which pull up to resp. signaling voltage.
In such cases, the carrier board-level device tree may explicitly delete
the no-1-8-v property to enable full UHS-I support.
Also, fix SD/MMC regulator for the carrier boards using UHS-I modes.
- FEC
Provide a proper phy-supply for the FEC, actually switched by the 50 Mhz
RMII interface clock using a regulator-fixed-clock that is now properly
stated. The reference commit for such regulator can be found at commit
8959e5324485 ("regulator: fixed: add possibility to enable by clock").
- I2C
Switched on 22 kOhm pull-ups and lower the I2C frequency to 40 kHz to
get more reliable communication.
- Atmel Touchscreen
The Toradex 7" Capacitive and 10" LVDS touch screens are Atmel MXT
peripherals available on the I2C bus for touchscreen events. Add
atmel_mxt_ts node to the module-level device tree. Also, provide pinmux
configuration for the INT/RST inputs from SODIMM pins 106/107 for most
carrier boards or an external touchscreen adapter inputs configured to
SODIMM pins 28/30.
Changes in v3:
- Fixed reset GPIO polarity in-line with the following upstream commit:
feedaacdadfc ("Input: atmel_mxt_ts - fix up inverted RESET handler")
- Fixed comment using more common SODIMM followed by number naming.
- Replaced underscores by dashes in GPIO hog node names.
- Added more LVDS specific GPIO hogs in-line with other modules.
- Re-based on top of Shawn's imx/dt branch.
- Dropped [PATCH v2 08/14] dt-bindings: arm: fsl: add
toradex,colibri-imx6ull which already got applied by Shawn. Thanks!
Changes in v2:
- Fixed pinctrl node names as suggested by Shawn.
- Fix alphabetical node order as suggested by Shawn.
- Dropped [PATCH v1 02/14] ARM: dts: imx6ull-colibri: fix vqmmc
regulator which already got applied by Shawn. Thanks!
- New commit with pinctrl node name improvements as suggested by Shawn.
Denys Drozdov (4):
ARM: dts: imx6ull-colibri: add touchscreen device nodes
ARM: dts: imx6ull-colibri: update device trees to support overlays
ARM: dts: imx6ull-colibri: add support for toradex iris carrier boards
ARM: dts: imx6ull-colibri: add support for toradex aster carrier
boards
Marcel Ziswiler (4):
ARM: dts: imx6ull-colibri: fix nand bch geometry
ARM: dts: imx6ull-colibri: add/update some comments
ARM: dts: imx6ull-colibri: move gpio-keys node to som dtsi
ARM: dts: imx6ull-colibri: improve pinctrl node names
Max Krummenacher (1):
ARM: dts: imx6ull-colibri: change touch i2c parameters
Oleksandr Suvorov (1):
ARM: dts: imx6ull-colibri: add gpio-line-names
Philippe Schenker (3):
ARM: dts: imx6ull-colibri: use pull-down for adc pins
ARM: dts: imx6ull-colibri: add phy-supply to fec
ARM: dts: imx6ull-colibri: update usdhc1 pixmux and signaling
arch/arm/boot/dts/Makefile | 9 +
arch/arm/boot/dts/imx6ull-colibri-aster.dts | 20 ++
arch/arm/boot/dts/imx6ull-colibri-aster.dtsi | 145 +++++++++
.../boot/dts/imx6ull-colibri-emmc-aster.dts | 17 ++
.../boot/dts/imx6ull-colibri-emmc-iris-v2.dts | 17 ++
.../boot/dts/imx6ull-colibri-emmc-iris.dts | 17 ++
.../dts/imx6ull-colibri-emmc-nonwifi.dtsi | 8 +-
arch/arm/boot/dts/imx6ull-colibri-eval-v3.dts | 6 +-
.../arm/boot/dts/imx6ull-colibri-eval-v3.dtsi | 63 +---
arch/arm/boot/dts/imx6ull-colibri-iris-v2.dts | 65 ++++
.../arm/boot/dts/imx6ull-colibri-iris-v2.dtsi | 27 ++
arch/arm/boot/dts/imx6ull-colibri-iris.dts | 20 ++
arch/arm/boot/dts/imx6ull-colibri-iris.dtsi | 132 ++++++++
.../arm/boot/dts/imx6ull-colibri-nonwifi.dtsi | 145 ++++++++-
.../boot/dts/imx6ull-colibri-wifi-aster.dts | 20 ++
.../boot/dts/imx6ull-colibri-wifi-eval-v3.dts | 4 +-
.../boot/dts/imx6ull-colibri-wifi-iris-v2.dts | 65 ++++
.../boot/dts/imx6ull-colibri-wifi-iris.dts | 20 ++
arch/arm/boot/dts/imx6ull-colibri-wifi.dtsi | 144 ++++++++-
arch/arm/boot/dts/imx6ull-colibri.dtsi | 285 ++++++++++++------
20 files changed, 1065 insertions(+), 164 deletions(-)
create mode 100644 arch/arm/boot/dts/imx6ull-colibri-aster.dts
create mode 100644 arch/arm/boot/dts/imx6ull-colibri-aster.dtsi
create mode 100644 arch/arm/boot/dts/imx6ull-colibri-emmc-aster.dts
create mode 100644 arch/arm/boot/dts/imx6ull-colibri-emmc-iris-v2.dts
create mode 100644 arch/arm/boot/dts/imx6ull-colibri-emmc-iris.dts
create mode 100644 arch/arm/boot/dts/imx6ull-colibri-iris-v2.dts
create mode 100644 arch/arm/boot/dts/imx6ull-colibri-iris-v2.dtsi
create mode 100644 arch/arm/boot/dts/imx6ull-colibri-iris.dts
create mode 100644 arch/arm/boot/dts/imx6ull-colibri-iris.dtsi
create mode 100644 arch/arm/boot/dts/imx6ull-colibri-wifi-aster.dts
create mode 100644 arch/arm/boot/dts/imx6ull-colibri-wifi-iris-v2.dts
create mode 100644 arch/arm/boot/dts/imx6ull-colibri-wifi-iris.dts
--
2.35.1
