The vbus-regulator property was never actually read from the device tree.
Introduce a new property vbus-supply to represent the regulator powering
the VBUS when acting as an A-Device. This supply will be enabled and
disabled as necessary. Note that this is different from vbus-regulator,
which represented the available current available to draw from VBUS in
B-Device mode. Because no one was using vbus-regulator, remove it.
Signed-off-by: Sean Anderson <sean.anderson@xxxxxxxx>
---
Changes in v2:
- Fix dt_binding_check errors
Documentation/devicetree/bindings/usb/usb-nop-xceiv.yaml | 9 ++++-----
1 file changed, 4 insertions(+), 5 deletions(-)
diff --git a/Documentation/devicetree/bindings/usb/usb-nop-xceiv.yaml b/Documentation/devicetree/bindings/usb/usb-nop-xceiv.yaml
index 2824c17285ee..b4517b01616f 100644
--- a/Documentation/devicetree/bindings/usb/usb-nop-xceiv.yaml
+++ b/Documentation/devicetree/bindings/usb/usb-nop-xceiv.yaml
@@ -34,10 +34,9 @@ properties:
description: Should specify the GPIO detecting a VBus insertion
maxItems: 1
- vbus-regulator:
- description: Should specifiy the regulator supplying current drawn from
- the VBus line.
- $ref: /schemas/types.yaml#/definitions/phandle
+ vbus-supply:
+ description: regulator supplying VBUS. It will be enabled and disabled
+ dynamically in OTG mode.
required:
- compatible
@@ -57,7 +56,7 @@ examples:
vcc-supply = <&hsusb1_vcc_regulator>;
reset-gpios = <&gpio1 7 GPIO_ACTIVE_LOW>;
vbus-detect-gpio = <&gpio2 13 GPIO_ACTIVE_HIGH>;
- vbus-regulator = <&vbus_regulator>;
+ vbus-supply = <&vbus_regulator>;
#phy-cells = <0>;
};
--
2.35.1.1320.gc452695387.dirty
