On Mon, Apr 11, 2022 at 05:11:57PM +0800, Changming Huang wrote:
> Enable MikroBUS SPI port.
>
> Signed-off-by: Jianchao Wang <jianchao.wang@xxxxxxx>
> Signed-off-by: Changming Huang <jerry.huang@xxxxxxx>
> ---
> arch/arm64/boot/dts/freescale/fsl-ls1028a-rdb.dts | 13 +++++++++++++
"arm64: dts: fsl-ls1028a-rdb: ..." to make it clear this is a board
rather than SoC change.
> 1 file changed, 13 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/freescale/fsl-ls1028a-rdb.dts b/arch/arm64/boot/dts/freescale/fsl-ls1028a-rdb.dts
> index 68c31cb8eead..6d0508d5abd0 100644
> --- a/arch/arm64/boot/dts/freescale/fsl-ls1028a-rdb.dts
> +++ b/arch/arm64/boot/dts/freescale/fsl-ls1028a-rdb.dts
> @@ -117,6 +117,19 @@ &duart1 {
> status = "okay";
> };
>
> +&dspi2 {
> + bus-num = <2>;
> + status = "okay";
> +
> + mikrobus@0 {
> + compatible = "semtech,sx1301";
Where is the bindings for this?
Shawn
> + reg = <0>;
> + spi-max-frequency = <2000000>;
> + fsl,spi-cs-sck-delay = <1000000>;
> + fsl,spi-sck-cs-delay = <50>;
> + };
> +};
> +
> &enetc_mdio_pf3 {
> sgmii_phy0: ethernet-phy@2 {
> reg = <0x2>;
> --
> 2.25.1
>
