On 09/09/2014 12:55 PM, Mark Brown wrote:
On Tue, Sep 09, 2014 at 07:07:31PM +0300, Grygorii Strashko wrote:
- ti,spi-c2t-delay: Chip-select-active-to-transmit-start delay
(SPIDELAY.C2TDELAY)
- ti,spi-t2c-delay: Transmit-end-to-chip-select-inactive delay
(SPIDELAY.T2CDELAY)
Now I look at these they look very much like the standard delay feature
that the SPI subsystem has already - are they?
Mark,
As Grygorii explained in previous postings (reproduced below), these
delays are handled by the SPI hardware on Keystone and affect the delay
between successive word tranmssion and has nothing to do with the delay
you are talking about. Isn't the standard delay you mention here is
between successive packets send down to the lower level driver (in this
case spi-davinci.c) ?
Murali
Below is timing diagram which shows, in general, how these new
parameters affect on words transmission over Keystone/Davinci SPI bus:
+-+ +-+ +-+ +-+ +-+ +-+ +-+ +-+
SPI_CLK | | | | | | | | | | | | | | | |
+----------+ +-+ +-+ +-+ +-+ +---------------------------+ +-+ +-+ +-
SPI_SOMI/SIMO+-----------------+ +-----------
+----------+ word1 +---------------------------+word2
+-----------------+ +-----------
WDELAY
<--------->
+ +
SPI_CS | |
+----+ +-----------+
| | |
+-----+-----------------+--------+ +-----+------------
| | | | | |
+ + + | + +
<---> <------> <--->
C2TDELAY T2CDELAY C2TDELAY
Where:
WDELAY - Delay in between transmissions
C2TDELAY - Chip-select-active-to-transmit-start-delay
T2CDELAY - Transmit-end-to-chip-select-inactive-delay
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
