Most of SoC device trees do not provide the thermal_zones label. Thus
stop depending on it and use the full path to the thermal zones nodes.
Fixes: 3795fe7d497b ("arm64: dts: qcom: pm8350c: Add temp-alarm support")
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/pm8350c.dtsi | 32 ++++++++++++++-------------
1 file changed, 17 insertions(+), 15 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/pm8350c.dtsi b/arch/arm64/boot/dts/qcom/pm8350c.dtsi
index e1b75ae0a823..9bc6464477bd 100644
--- a/arch/arm64/boot/dts/qcom/pm8350c.dtsi
+++ b/arch/arm64/boot/dts/qcom/pm8350c.dtsi
@@ -32,23 +32,25 @@ pm8350c_gpios: gpio@8800 {
};
};
-&thermal_zones {
- pm8350c_thermal: pm8350c-thermal {
- polling-delay-passive = <100>;
- polling-delay = <0>;
- thermal-sensors = <&pm8350c_temp_alarm>;
+/ {
+ thermal-zones {
+ pm8350c_thermal: pm8350c-thermal {
+ polling-delay-passive = <100>;
+ polling-delay = <0>;
+ thermal-sensors = <&pm8350c_temp_alarm>;
- trips {
- pm8350c_trip0: trip0 {
- temperature = <95000>;
- hysteresis = <0>;
- type = "passive";
- };
+ trips {
+ pm8350c_trip0: trip0 {
+ temperature = <95000>;
+ hysteresis = <0>;
+ type = "passive";
+ };
- pm8350c_crit: pm8350c-crit {
- temperature = <115000>;
- hysteresis = <0>;
- type = "critical";
+ pm8350c_crit: pm8350c-crit {
+ temperature = <115000>;
+ hysteresis = <0>;
+ type = "critical";
+ };
};
};
};
--
2.30.2
