From: David Jander <david@xxxxxxxxxxx>
countedX lines have different board names (YACO_x). And REV_ and BOARD_ pins
have multiple functions. So, use names exposed to the OS.
Signed-off-by: David Jander <david@xxxxxxxxxxx>
Signed-off-by: Oleksij Rempel <o.rempel@xxxxxxxxxxxxxx>
---
arch/arm/boot/dts/imx6qdl-vicut1.dtsi | 12 +++++++-----
1 file changed, 7 insertions(+), 5 deletions(-)
diff --git a/arch/arm/boot/dts/imx6qdl-vicut1.dtsi b/arch/arm/boot/dts/imx6qdl-vicut1.dtsi
index 2f6b263eea66..ec39008c0950 100644
--- a/arch/arm/boot/dts/imx6qdl-vicut1.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-vicut1.dtsi
@@ -277,9 +277,9 @@ &gpio1 {
&gpio2 {
gpio-line-names =
- "count0", "count1", "count2", "", "", "", "", "",
- "REV_ID0", "REV_ID1", "REV_ID2", "REV_ID3", "REV_ID4",
- "BOARD_ID0", "BOARD_ID1", "BOARD_ID2",
+ "YACO_WHEEL", "YACO_RADAR", "YACO_PTO", "", "", "", "", "",
+ "", "LED_PWM", "", "", "",
+ "", "", "",
"", "", "", "", "", "", "", "ON_SWITCH",
"POWER_LED", "", "ECSPI2_SS0", "", "", "", "", "";
};
@@ -298,8 +298,10 @@ &gpio4 {
"", "", "", "", "", "", "UART4_TXD", "UART4_RXD",
"UART5_TXD", "UART5_RXD", "CAN1_TX", "CAN1_RX", "CAN1_SR",
"CAN2_SR", "CAN2_TX", "CAN2_RX",
- "LED_DI0_DEBUG_0", "LED_DI0_DEBUG_1", "", "", "", "", "", "",
- "", "", "", "", "BL_EN", "BL_PWM", "", "";
+ "LED_DI0_DEBUG_0", "LED_DI0_DEBUG_1", "", "", "", "ON1_CTRL",
+ "ON2_CTRL", "HITCH_IN_OUT",
+ "LIGHT_ON", "", "", "CONTACT_IN", "BL_EN", "BL_PWM", "",
+ "ISB_LED";
};
&gpio5 {
--
2.30.2
