14.12.2021 09:09, Dmitry Osipenko пишет: > 14.12.2021 09:02, Sameer Pujar пишет: >> >> >> On 12/8/2021 5:35 PM, Dmitry Osipenko wrote: >>> 08.12.2021 08:22, Sameer Pujar пишет: >>>> >>>> On 12/7/2021 11:32 PM, Dmitry Osipenko wrote >>>>> If display is already active, then shared power domain is already >>>>> ungated. >>>> If display is already active, then shared power domain is already >>>> ungated. HDA reset is already applied during this ungate. In other >>>> words, HDA would be reset as well when display ungates power-domain. >>> Now, if you'll reload the HDA driver module while display is active, >>> you'll get a different reset behaviour. HDA hardware will be reset on >>> pre-T186, on T186+ it won't be reset. >> >> How the reset behavior is different? At this point when HDA driver is >> loaded the HW is already reset during display ungate. What matters, >> during HDA driver load, is whether the HW is in predictable state or not >> and the answer is yes. So I am not sure what problem you are referring >> to. Question is, if BPMP already ensures this, then why driver needs to >> take care of it. > > 1. Enable display > 2. Play audio over HDMI > 3. HDA hardware now is in dirty state > 4. Reload HDA driver > 5. In your case HDA is kept in dirty state, in my no > The power domain is shared by display and HDA, is this correct? If yes, then the shared power domain will be turned off only when all its clients are turned off, i.e. both display and HDA simultaneously.
