Hi Joel Bletchley platform needs to support fan control. Since Billy's patch for upstream is still under review, I can't add pwm/tach node into dts or the build would fail. As you know, I had committed the pwm/tach driver for ast26xx to OpenBMC linux, could I commit the dts to OpenBMC linux instead of upstream for early build? Howard > -----Original Message----- > From: Joel Stanley <joel@xxxxxxxxx> > Sent: Tuesday, December 7, 2021 6:52 AM > To: Patrick Williams <patrick@xxxxxxxxx> > Cc: Howard Chiu <howard10703049@xxxxxxxxx>; Arnd Bergmann > <arnd@xxxxxxxx>; Olof Johansson <olof@xxxxxxxxx>; SoC Team > <soc@xxxxxxxxxx>; Rob Herring <robh+dt@xxxxxxxxxx>; Andrew Jeffery > <andrew@xxxxxxxx>; Linux ARM <linux-arm-kernel@xxxxxxxxxxxxxxxxxxx>; > devicetree <devicetree@xxxxxxxxxxxxxxx>; Linux Kernel Mailing List > <linux-kernel@xxxxxxxxxxxxxxx>; linux-aspeed <linux-aspeed@xxxxxxxxxxxxxxxx>; > Howard Chiu (邱冠睿) <Howard.Chiu@xxxxxxxxxxxx> > Subject: Re: [PATCH v6] ARM: dts: aspeed: Adding Facebook Bletchley BMC > > On Mon, 6 Dec 2021 at 21:25, Patrick Williams <patrick@xxxxxxxxx> wrote: > > > > On Wed, Dec 01, 2021 at 11:37:38AM +0800, Howard Chiu wrote: > > > Initial introduction of Facebook Bletchley equipped with > > > Aspeed 2600 BMC SoC. > > > > > > Signed-off-by: Howard Chiu <howard.chiu@xxxxxxxxxxxx> > > > > > > > ... > > > > > Change since v2: > > > - Remove uart5 workaround > > > - Remove gpio nodes of pca9552/pca9539 > > > - Modify gpio-line-name of led/power/presence pins with openbmc > pattern > > > > A number of the GPIOs do not have defined openbmc patterns for them yet. > The > > names you have chosen are ok for now, but we will be changing them as we > refine > > development of this machine further. > > > > > + gpio-line-names = > > > + > "SLED0_MS_DETECT1","SLED0_VBUS_BMC_EN","SLED0_INA230_ALERT","SLE > D0_P12V_STBY_ALERT", > > > + > "SLED0_SSD_ALERT","SLED0_MS_DETECT0","SLED0_RST_CCG5","SLED0_FUSB > 302_INT", > > > + > "SLED0_MD_STBY_RESET","SLED0_MD_IOEXP_EN_FAULT","SLED0_MD_DIR"," > SLED0_MD_DECAY", > > > + > "SLED0_MD_MODE1","SLED0_MD_MODE2","SLED0_MD_MODE3","power-ho > st0"; > > > > Such as these... > > > > > -- > > > 2.25.1 > > > > > > > Otherwise, > > > > Reviewed-by: Patrick Williams <patrick@xxxxxxxxx> > > Thanks for reviewing. > > Howard, I'm merging patches for v5.17 but I can't apply this until you > fix the warnings I mentioned. > > Cheers, > > Jeol > > > > -- > > Patrick Williams
