Hi All, I've run into a problem trying to accurately model some hardware. In this particular design there are a bunch of pca9548 i2c muxes and some of them share the same reset pins coming out of a custom FPGA (we've written a gpio driver to represent that part of the FPGA). Initially we had this working by using a gpio-hog for the reset lines and pretty much forgetting they were there. If I start building the fpga-gpio driver as a module I run into a situation where there is an implicit dependency between the fpga-gpio driver and the pca954x i2c muxes. Because it's implicit the pca954x_probe runs early and fails for these devices. I can make that dependency explicit by using the reset-gpios property which correctly defers the probe until the fpga-gpio driver is loaded. But as some of these pca9548 share reset lines they ones that get probed second get -EBUSY when they request the GPIO. Is there any way I can represent these pca9548 devices as a group with a single reset-gpio property for the group? Thanks, Chris
