Mark it as read-only as it is factory-programmed with identifying information, and no executable nor configuration: - eth MAC address - board model (PCB version, BoM version) - board serial number Accidental modification would cause misidentification which could brick the board, so marking read-only seem like both a safe and non-constraining choice. Signed-off-by: Vincent Pelletier <plr.vincent@xxxxxxxxx> --- Changes since v2: - Fix end-of-commit-message separator so change lists do not end up in them. Changes since v1: - Remove trailing "." on subject line. --- arch/riscv/boot/dts/sifive/hifive-unmatched-a00.dts | 10 ++++++++++ 1 file changed, 10 insertions(+) diff --git a/arch/riscv/boot/dts/sifive/hifive-unmatched-a00.dts b/arch/riscv/boot/dts/sifive/hifive-unmatched-a00.dts index 305a086e5207..cf8937708829 100644 --- a/arch/riscv/boot/dts/sifive/hifive-unmatched-a00.dts +++ b/arch/riscv/boot/dts/sifive/hifive-unmatched-a00.dts @@ -58,6 +58,16 @@ temperature-sensor@4c { interrupts = <6 IRQ_TYPE_LEVEL_LOW>; }; + eeprom@54 { + compatible = "microchip,24c02", "atmel,24c02"; + reg = <0x54>; + vcc-supply = <&vdd_bpro>; + label = "board-id"; + pagesize = <16>; + read-only; + size = <256>; + }; + pmic@58 { compatible = "dlg,da9063"; reg = <0x58>; -- 2.33.1