Enable/disable internal i2c controller slave autoprobing at bootstrap.
Disable sensor-hub is useful if i2c controller clock/data lines are
connected through a pull-up with other chip lines (e.g. SDO/SA0).
Signed-off-by: Lorenzo Bianconi <lorenzo@xxxxxxxxxx>
---
Documentation/devicetree/bindings/iio/imu/st,lsm6dsx.yaml | 7 +++++++
1 file changed, 7 insertions(+)
diff --git a/Documentation/devicetree/bindings/iio/imu/st,lsm6dsx.yaml b/Documentation/devicetree/bindings/iio/imu/st,lsm6dsx.yaml
index d9b3213318fb..0750f700a143 100644
--- a/Documentation/devicetree/bindings/iio/imu/st,lsm6dsx.yaml
+++ b/Documentation/devicetree/bindings/iio/imu/st,lsm6dsx.yaml
@@ -61,6 +61,13 @@ properties:
type: boolean
description: enable/disable internal i2c controller pullup resistors.
+ st,disable-sensor-hub:
+ type: boolean
+ description:
+ Enable/disable internal i2c controller slave autoprobing at bootstrap.
+ Disable sensor-hub is useful if i2c controller clock/data lines are
+ connected through a pull-up with other chip lines (e.g. SDO/SA0).
+
drive-open-drain:
type: boolean
description:
--
2.31.1
