This patch update DT binding to support INn_MODE init_data. Each input signal path can be configurated either as a Analogue or Digital using the INn_MODE registers. Signed-off-by: Inha Song <ideal.song@xxxxxxxxxxx> --- Documentation/devicetree/bindings/mfd/arizona.txt | 8 ++++++++ 1 file changed, 8 insertions(+) diff --git a/Documentation/devicetree/bindings/mfd/arizona.txt b/Documentation/devicetree/bindings/mfd/arizona.txt index 5c7e723..0064b21 100644 --- a/Documentation/devicetree/bindings/mfd/arizona.txt +++ b/Documentation/devicetree/bindings/mfd/arizona.txt @@ -42,6 +42,14 @@ Optional properties: the chip default will be used. If present exactly five values must be specified. + - wlf,inmode : A list of INn_MODE register values, where n is the number + of input signals. Each input signal path can be configurated either as a + Analogue or Digital using the INn_MODE registers. If absent, INn_MODE + registers set to 0 by default. If present, values must be specified less + than or equal to the number of input singals. If values less than the + number of input signals, elements that has not been specifed are set to 0 + by default. + - DCVDD-supply, MICVDD-supply : Power supplies, only need to be specified if they are being externally supplied. As covered in Documentation/devicetree/bindings/regulator/regulator.txt -- 2.0.0.390.gcb682f8 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html