[RFC PATCH 3/3] remoteproc: Add Renesas rcar driver

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Renesas Gen3 platform includes a Cortex-r7 processor.

Both: the application cores (A5x) and the realtime core (CR7)
share access to the RAM and devices with the same address map,
so device addresses are equal to the Linux physical addresses.

In order to initialize this remote processor we need to:
- power on the realtime core
- put the firmware in a ram area
- set the boot address for this firmware (reset vector)
- Deassert the reset

This initial driver allows to start and stop the Cortex R7
processor.

Signed-off-by: Julien Massot <julien.massot@xxxxxxx>
---
 drivers/remoteproc/Kconfig      |  11 ++
 drivers/remoteproc/Makefile     |   1 +
 drivers/remoteproc/rcar_rproc.c | 229 ++++++++++++++++++++++++++++++++
 3 files changed, 241 insertions(+)
 create mode 100644 drivers/remoteproc/rcar_rproc.c

diff --git a/drivers/remoteproc/Kconfig b/drivers/remoteproc/Kconfig
index 9a6eedc3994a..3e87eadbaf59 100644
--- a/drivers/remoteproc/Kconfig
+++ b/drivers/remoteproc/Kconfig
@@ -261,6 +261,17 @@ config QCOM_WCNSS_PIL
 	  verified and booted with the help of the Peripheral Authentication
 	  System (PAS) in TrustZone.
 
+config RCAR_REMOTEPROC
+	tristate "Renesas RCAR remoteproc support"
+	depends on ARCH_RENESAS
+	depends on REMOTEPROC
+	help
+	  Say y here to support R-Car realtime processor via the
+	  remote processor framework. An elf firmware can be loaded
+	  thanks to sysfs remoteproc entries. The remote processor
+	  can be started and stopped.
+	  This can be either built-in or a loadable module.
+
 config ST_REMOTEPROC
 	tristate "ST remoteproc support"
 	depends on ARCH_STI
diff --git a/drivers/remoteproc/Makefile b/drivers/remoteproc/Makefile
index bb26c9e4ef9c..bb290cc08e99 100644
--- a/drivers/remoteproc/Makefile
+++ b/drivers/remoteproc/Makefile
@@ -30,6 +30,7 @@ obj-$(CONFIG_QCOM_SYSMON)		+= qcom_sysmon.o
 obj-$(CONFIG_QCOM_WCNSS_PIL)		+= qcom_wcnss_pil.o
 qcom_wcnss_pil-y			+= qcom_wcnss.o
 qcom_wcnss_pil-y			+= qcom_wcnss_iris.o
+obj-$(CONFIG_RCAR_REMOTEPROC)		+= rcar_rproc.o
 obj-$(CONFIG_ST_REMOTEPROC)		+= st_remoteproc.o
 obj-$(CONFIG_ST_SLIM_REMOTEPROC)	+= st_slim_rproc.o
 obj-$(CONFIG_STM32_RPROC)		+= stm32_rproc.o
diff --git a/drivers/remoteproc/rcar_rproc.c b/drivers/remoteproc/rcar_rproc.c
new file mode 100644
index 000000000000..ae0bfc8d4e85
--- /dev/null
+++ b/drivers/remoteproc/rcar_rproc.c
@@ -0,0 +1,229 @@
+// SPDX-License-Identifier: GPL-2.0
+/*
+ * Copyright (C) IoT.bzh 2021
+ */
+
+#include <linux/module.h>
+#include <linux/of_device.h>
+#include <linux/of_reserved_mem.h>
+#include <linux/pm_runtime.h>
+#include <linux/remoteproc.h>
+#include <linux/reset.h>
+#include <linux/soc/renesas/rcar-rst.h>
+
+#include "remoteproc_internal.h"
+
+struct rcar_rproc {
+	struct device			*dev;
+	struct rproc			*rproc;
+	struct reset_control            *rst;
+};
+
+static int rcar_rproc_mem_alloc(struct rproc *rproc,
+				 struct rproc_mem_entry *mem)
+{
+	struct device *dev = rproc->dev.parent;
+	void *va;
+
+	dev_dbg(dev, "map memory: %p+%zx\n", &mem->dma, mem->len);
+	va = ioremap_wc(mem->dma, mem->len);
+	if (IS_ERR_OR_NULL(va)) {
+		dev_err(dev, "Unable to map memory region: %pa+%lx\n",
+			&mem->dma, mem->len);
+		return -ENOMEM;
+	}
+
+	/* Update memory entry va */
+	mem->va = va;
+
+	return 0;
+}
+
+static int rcar_rproc_mem_release(struct rproc *rproc,
+				   struct rproc_mem_entry *mem)
+{
+	dev_dbg(rproc->dev.parent, "unmap memory: %pa\n", &mem->dma);
+	iounmap(mem->va);
+
+	return 0;
+}
+
+static int rcar_rproc_prepare(struct rproc *rproc)
+{
+	struct device *dev = rproc->dev.parent;
+	struct device_node *np = dev->of_node;
+	struct of_phandle_iterator it;
+	struct rproc_mem_entry *mem;
+	struct reserved_mem *rmem;
+	u64 da;
+
+	/* Register associated reserved memory regions */
+	of_phandle_iterator_init(&it, np, "memory-region", NULL, 0);
+	while (of_phandle_iterator_next(&it) == 0) {
+
+		rmem = of_reserved_mem_lookup(it.node);
+		if (!rmem) {
+			dev_err(dev, "unable to acquire memory-region\n");
+			return -EINVAL;
+		}
+
+		/* No need to translate pa to da, R-Car use same map */
+		da = rmem->base;
+
+		mem = rproc_mem_entry_init(dev, NULL,
+					   (dma_addr_t)rmem->base,
+					   rmem->size, da,
+					   rcar_rproc_mem_alloc,
+					   rcar_rproc_mem_release,
+					   it.node->name);
+
+		if (!mem)
+			return -ENOMEM;
+
+		rproc_add_carveout(rproc, mem);
+	}
+
+	return 0;
+}
+
+static int rcar_rproc_parse_fw(struct rproc *rproc, const struct firmware *fw)
+{
+	int ret;
+
+	ret = rproc_elf_load_rsc_table(rproc, fw);
+	if (ret)
+		dev_info(&rproc->dev, "No resource table in elf\n");
+
+	return 0;
+}
+
+static int rcar_rproc_start(struct rproc *rproc)
+{
+	struct rcar_rproc *priv = rproc->priv;
+	int err;
+
+	if (!rproc->bootaddr)
+		return -EINVAL;
+
+	err = rcar_rst_set_rproc_boot_addr(rproc->bootaddr);
+	if (err) {
+		dev_err(&rproc->dev, "failed to set rproc boot addr\n");
+		return err;
+	}
+
+	err = reset_control_deassert(priv->rst);
+	if (err)
+		dev_err(&rproc->dev, "failed to deassert reset\n");
+
+	return err;
+}
+
+static int rcar_rproc_stop(struct rproc *rproc)
+{
+	struct rcar_rproc *priv = rproc->priv;
+	int err;
+
+	err = reset_control_assert(priv->rst);
+	if (err)
+		dev_err(&rproc->dev, "failed to assert reset\n");
+
+	return err;
+}
+
+static struct rproc_ops rcar_rproc_ops = {
+	.prepare	= rcar_rproc_prepare,
+	.start		= rcar_rproc_start,
+	.stop		= rcar_rproc_stop,
+	.load		= rproc_elf_load_segments,
+	.parse_fw	= rcar_rproc_parse_fw,
+	.find_loaded_rsc_table = rproc_elf_find_loaded_rsc_table,
+	.sanity_check	= rproc_elf_sanity_check,
+	.get_boot_addr	= rproc_elf_get_boot_addr,
+
+};
+
+static int rcar_rproc_probe(struct platform_device *pdev)
+{
+	struct device *dev = &pdev->dev;
+	struct device_node *np = dev->of_node;
+	struct rcar_rproc *priv;
+	struct rproc *rproc;
+	int ret;
+
+	rproc = rproc_alloc(dev, np->name, &rcar_rproc_ops,
+			    NULL, sizeof(*priv));
+	if (!rproc)
+		return -ENOMEM;
+
+	priv = rproc->priv;
+	priv->rproc = rproc;
+	priv->dev = dev;
+
+	priv->rst = devm_reset_control_get_exclusive(&pdev->dev, NULL);
+	if (IS_ERR(priv->rst)) {
+		ret = PTR_ERR(priv->rst);
+		dev_err(dev, "fail to acquire rproc reset\n");
+		goto free_rproc;
+	}
+
+	pm_runtime_enable(priv->dev);
+	ret = pm_runtime_get_sync(priv->dev);
+	if (ret) {
+		dev_err(&rproc->dev, "failed to power up\n");
+		goto free_rproc;
+	}
+
+	dev_set_drvdata(dev, rproc);
+
+	/* Manually start the rproc */
+	rproc->auto_boot = false;
+
+	ret = rproc_add(rproc);
+	if (ret) {
+		dev_err(dev, "rproc_add failed\n");
+		goto pm_disable;
+	}
+
+	return 0;
+
+pm_disable:
+	pm_runtime_disable(priv->dev);
+free_rproc:
+	rproc_free(rproc);
+
+	return ret;
+}
+
+static int rcar_rproc_remove(struct platform_device *pdev)
+{
+	struct rproc *rproc = platform_get_drvdata(pdev);
+	struct rcar_rproc *priv = rproc->priv;
+
+	rproc_del(rproc);
+	pm_runtime_disable(priv->dev);
+	rproc_free(rproc);
+
+	return 0;
+}
+
+static const struct of_device_id rcar_rproc_of_match[] = {
+	{ .compatible = "renesas,rcar-cr7" },
+	{},
+};
+
+MODULE_DEVICE_TABLE(of, rcar_rproc_of_match);
+
+static struct platform_driver rcar_rproc_driver = {
+	.probe = rcar_rproc_probe,
+	.remove = rcar_rproc_remove,
+	.driver = {
+		.name = "rcar-rproc",
+		.of_match_table = rcar_rproc_of_match,
+	},
+};
+
+module_platform_driver(rcar_rproc_driver);
+
+MODULE_LICENSE("GPL v2");
+MODULE_DESCRIPTION("Renesas Gen3 R-Car remote processor control driver");
+MODULE_AUTHOR("Julien Massot <julien.massot@xxxxxxx>");
-- 
2.31.1





[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux