pinctrl settings for the USB hub, barometer & accelerometer need to be
referenced from the relevant nodes to work.
Signed-off-by: Paul Barker <paul.barker@xxxxxxxxxxxx>
---
arch/arm/boot/dts/am335x-sancloud-bbe-common.dtsi | 2 ++
arch/arm/boot/dts/am335x-sancloud-bbe.dts | 4 ++++
2 files changed, 6 insertions(+)
diff --git a/arch/arm/boot/dts/am335x-sancloud-bbe-common.dtsi b/arch/arm/boot/dts/am335x-sancloud-bbe-common.dtsi
index 627c18d23f94..55952fe8687c 100644
--- a/arch/arm/boot/dts/am335x-sancloud-bbe-common.dtsi
+++ b/arch/arm/boot/dts/am335x-sancloud-bbe-common.dtsi
@@ -58,6 +58,8 @@ &cpsw_port1 {
&i2c0 {
usb2512b: usb-hub@2c {
+ pinctrl-names = "default";
+ pinctrl-0 = <&usb_hub_ctrl>;
compatible = "microchip,usb2512b";
reg = <0x2c>;
reset-gpios = <&gpio0 29 GPIO_ACTIVE_LOW>;
diff --git a/arch/arm/boot/dts/am335x-sancloud-bbe.dts b/arch/arm/boot/dts/am335x-sancloud-bbe.dts
index 2a0ac9f5dda7..efbe93135dbe 100644
--- a/arch/arm/boot/dts/am335x-sancloud-bbe.dts
+++ b/arch/arm/boot/dts/am335x-sancloud-bbe.dts
@@ -32,6 +32,8 @@ AM33XX_PADCONF(AM335X_PIN_GPMC_A10, PIN_INPUT, MUX_MODE7) /* gpmc_a10.gpio1_
&i2c0 {
lps331ap: barometer@5c {
+ pinctrl-names = "default";
+ pinctrl-0 = <&lps3331ap_pins>;
compatible = "st,lps331ap-press";
st,drdy-int-pin = <1>;
reg = <0x5c>;
@@ -40,6 +42,8 @@ lps331ap: barometer@5c {
};
mpu6050: accelerometer@68 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&mpu6050_pins>;
compatible = "invensense,mpu6050";
reg = <0x68>;
interrupt-parent = <&gpio0>;
--
2.31.1
