Hi Rob,
On 2021/6/16 下午11:38, Rob Herring wrote:
On Fri, Jun 11, 2021 at 10:33 AM Ezequiel Garcia
<ezequiel@xxxxxxxxxxxxxxxxxxxx> wrote:
Hi all,
On Thu, 10 Jun 2021 at 00:04, Kever Yang <kever.yang@xxxxxxxxxxxxxx> wrote:
Hi Rob,
On 2021/6/10 上午10:43, Rob Herring wrote:
On Wed, Jun 09, 2021 at 10:04:04PM +0800, Jon Lin wrote:
From: Chris Morgan <macromorgan@xxxxxxxxxxx>
Add bindings for the Rockchip serial flash controller. New device
specific parameter of rockchip,sfc-no-dma included in documentation.
Signed-off-by: Chris Morgan <macromorgan@xxxxxxxxxxx>
Signed-off-by: Jon Lin <jon.lin@xxxxxxxxxxxxxx>
---
Changes in v7:
- Fix up the sclk_sfc parent error in rk3036
- Unify to "rockchip,sfc" compatible id because all the feature update
will have a new IP version, so the driver is used for the SFC IP in
all SoCs
- Change to use node "sfc" to name the SFC pinctrl group
- Add subnode reg property check
- Add rockchip_sfc_adjust_op_size to workaround in CMD + DUMMY case
- Limit max_iosize to 32KB
Changes in v6:
- Add support in device trees for rv1126(Declared in series 5 but not
submitted)
- Change to use "clk_sfc" "hclk_sfc" as clock lable, since it does not
affect interpretation and has been widely used
- Support sfc tx_dual, tx_quad(Declared in series 5 but not submitted)
- Simplify the code, such as remove "rockchip_sfc_register_all"(Declared
in series 5 but not submitted)
- Support SFC ver4 ver5(Declared in series 5 but not submitted)
- Add author Chris Morgan and Jon Lin to spi-rockchip-sfc.c
- Change to use devm_spi_alloc_master and spi_unregister_master
Changes in v5:
- Add support in device trees for rv1126
- Support sfc tx_dual, tx_quad
- Simplify the code, such as remove "rockchip_sfc_register_all"
- Support SFC ver4 ver5
Changes in v4:
- Changing patch back to an "RFC". An engineer from Rockchip
reached out to me to let me know they are working on this patch for
upstream, I am submitting this v4 for the community to see however
I expect Jon Lin (jon.lin@xxxxxxxxxxxxxx) will submit new patches
soon and these are the ones we should pursue for mainlining. Jon's
patch series should include support for more hardware than this
series.
- Clean up documentation more and ensure it is correct per
make dt_binding_check.
- Add support in device trees for rk3036, rk3308, and rv1108.
- Add ahb clock (hclk_sfc) support for rk3036.
- Change rockchip_sfc_wait_fifo_ready() to use a switch statement.
- Change IRQ code to only mark IRQ as handled if it handles the
specific IRQ (DMA transfer finish) it is supposed to handle.
Changes in v3:
- Changed the name of the clocks to sfc/ahb (from clk-sfc/clk-hsfc).
- Changed the compatible string from rockchip,sfc to
rockchip,rk3036-sfc. A quick glance at the datasheets suggests this
driver should work for the PX30, RK180x, RK3036, RK312x, RK3308 and
RV1108 SoCs, and possibly more. However, I am currently only able
to test this on a PX30 (an RK3326). The technical reference manuals
appear to list the same registers for each device.
- Corrected devicetree documentation for formatting and to note these
changes.
- Replaced the maintainer with Heiko Stuebner and myself, as we will
take ownership of this going forward.
- Noted that the device (per the reference manual) supports 4 CS, but
I am only able to test a single CS (CS 0).
- Reordered patches to comply with upstream rules.
Changes in v2:
- Reimplemented driver using spi-mem subsystem.
- Removed power management code as I couldn't get it working properly.
- Added device tree bindings for Odroid Go Advance.
Changes in v1:
hanges made in this new series versus the v8 of the old series:
- Added function to read spi-rx-bus-width from device tree, in the
event that the SPI chip supports 4x mode but only has 2 pins
wired (such as the Odroid Go Advance).
- Changed device tree documentation from txt to yaml format.
- Made "reset" message a dev_dbg from a dev_info.
- Changed read and write fifo functions to remove redundant checks.
- Changed the write and read from relaxed to non-relaxed when
starting the DMA transfer or reading the DMA IRQ.
- Changed from dma_coerce_mask_and_coherent to just
dma_set_mask_and_coherent.
- Changed name of get_if_type to rockchip_sfc_get_if_type.
.../devicetree/bindings/spi/rockchip-sfc.yaml | 88 +++++++++++++++++++
1 file changed, 88 insertions(+)
create mode 100644 Documentation/devicetree/bindings/spi/rockchip-sfc.yaml
diff --git a/Documentation/devicetree/bindings/spi/rockchip-sfc.yaml b/Documentation/devicetree/bindings/spi/rockchip-sfc.yaml
new file mode 100644
index 000000000000..42e4198e92af
--- /dev/null
+++ b/Documentation/devicetree/bindings/spi/rockchip-sfc.yaml
@@ -0,0 +1,88 @@
+# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
+%YAML 1.2
+---
+$id: http://devicetree.org/schemas/spi/rockchip-sfc.yaml#
+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: Rockchip Serial Flash Controller (SFC)
+
+maintainers:
+ - Heiko Stuebner <heiko@xxxxxxxxx>
+ - Chris Morgan <macromorgan@xxxxxxxxxxx>
+
+allOf:
+ - $ref: spi-controller.yaml#
+
+properties:
+ compatible:
+ oneOf:
+ - const: rockchip,sfc
Use 'enum' instead of oneOf+const.
You need an SoC specific compatible.
The rockchip sfc controller is a standalone IP with version register,
and the driver can
handle all the feature difference inside the IP, so we would like to use
a more generic
Okay, if the version register can be relied on, then this is fine.
Just add a comment that further differentiation is done using a
version register.
Thanks for your confirm, this will make things much simple for driver
maintain.
@Jon, please update your patch per Rob's requirement.
Thanks,
- Kever
