On Wed, Jun 09, 2021 at 10:04:04PM +0800, Jon Lin wrote: > From: Chris Morgan <macromorgan@xxxxxxxxxxx> > > Add bindings for the Rockchip serial flash controller. New device > specific parameter of rockchip,sfc-no-dma included in documentation. > > Signed-off-by: Chris Morgan <macromorgan@xxxxxxxxxxx> > Signed-off-by: Jon Lin <jon.lin@xxxxxxxxxxxxxx> > --- > > Changes in v7: > - Fix up the sclk_sfc parent error in rk3036 > - Unify to "rockchip,sfc" compatible id because all the feature update > will have a new IP version, so the driver is used for the SFC IP in > all SoCs > - Change to use node "sfc" to name the SFC pinctrl group > - Add subnode reg property check > - Add rockchip_sfc_adjust_op_size to workaround in CMD + DUMMY case > - Limit max_iosize to 32KB > > Changes in v6: > - Add support in device trees for rv1126(Declared in series 5 but not > submitted) > - Change to use "clk_sfc" "hclk_sfc" as clock lable, since it does not > affect interpretation and has been widely used > - Support sfc tx_dual, tx_quad(Declared in series 5 but not submitted) > - Simplify the code, such as remove "rockchip_sfc_register_all"(Declared > in series 5 but not submitted) > - Support SFC ver4 ver5(Declared in series 5 but not submitted) > - Add author Chris Morgan and Jon Lin to spi-rockchip-sfc.c > - Change to use devm_spi_alloc_master and spi_unregister_master > > Changes in v5: > - Add support in device trees for rv1126 > - Support sfc tx_dual, tx_quad > - Simplify the code, such as remove "rockchip_sfc_register_all" > - Support SFC ver4 ver5 > > Changes in v4: > - Changing patch back to an "RFC". An engineer from Rockchip > reached out to me to let me know they are working on this patch for > upstream, I am submitting this v4 for the community to see however > I expect Jon Lin (jon.lin@xxxxxxxxxxxxxx) will submit new patches > soon and these are the ones we should pursue for mainlining. Jon's > patch series should include support for more hardware than this > series. > - Clean up documentation more and ensure it is correct per > make dt_binding_check. > - Add support in device trees for rk3036, rk3308, and rv1108. > - Add ahb clock (hclk_sfc) support for rk3036. > - Change rockchip_sfc_wait_fifo_ready() to use a switch statement. > - Change IRQ code to only mark IRQ as handled if it handles the > specific IRQ (DMA transfer finish) it is supposed to handle. > > Changes in v3: > - Changed the name of the clocks to sfc/ahb (from clk-sfc/clk-hsfc). > - Changed the compatible string from rockchip,sfc to > rockchip,rk3036-sfc. A quick glance at the datasheets suggests this > driver should work for the PX30, RK180x, RK3036, RK312x, RK3308 and > RV1108 SoCs, and possibly more. However, I am currently only able > to test this on a PX30 (an RK3326). The technical reference manuals > appear to list the same registers for each device. > - Corrected devicetree documentation for formatting and to note these > changes. > - Replaced the maintainer with Heiko Stuebner and myself, as we will > take ownership of this going forward. > - Noted that the device (per the reference manual) supports 4 CS, but > I am only able to test a single CS (CS 0). > - Reordered patches to comply with upstream rules. > > Changes in v2: > - Reimplemented driver using spi-mem subsystem. > - Removed power management code as I couldn't get it working properly. > - Added device tree bindings for Odroid Go Advance. > > Changes in v1: > hanges made in this new series versus the v8 of the old series: > - Added function to read spi-rx-bus-width from device tree, in the > event that the SPI chip supports 4x mode but only has 2 pins > wired (such as the Odroid Go Advance). > - Changed device tree documentation from txt to yaml format. > - Made "reset" message a dev_dbg from a dev_info. > - Changed read and write fifo functions to remove redundant checks. > - Changed the write and read from relaxed to non-relaxed when > starting the DMA transfer or reading the DMA IRQ. > - Changed from dma_coerce_mask_and_coherent to just > dma_set_mask_and_coherent. > - Changed name of get_if_type to rockchip_sfc_get_if_type. > > .../devicetree/bindings/spi/rockchip-sfc.yaml | 88 +++++++++++++++++++ > 1 file changed, 88 insertions(+) > create mode 100644 Documentation/devicetree/bindings/spi/rockchip-sfc.yaml > > diff --git a/Documentation/devicetree/bindings/spi/rockchip-sfc.yaml b/Documentation/devicetree/bindings/spi/rockchip-sfc.yaml > new file mode 100644 > index 000000000000..42e4198e92af > --- /dev/null > +++ b/Documentation/devicetree/bindings/spi/rockchip-sfc.yaml > @@ -0,0 +1,88 @@ > +# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) > +%YAML 1.2 > +--- > +$id: http://devicetree.org/schemas/spi/rockchip-sfc.yaml# > +$schema: http://devicetree.org/meta-schemas/core.yaml# > + > +title: Rockchip Serial Flash Controller (SFC) > + > +maintainers: > + - Heiko Stuebner <heiko@xxxxxxxxx> > + - Chris Morgan <macromorgan@xxxxxxxxxxx> > + > +allOf: > + - $ref: spi-controller.yaml# > + > +properties: > + compatible: > + oneOf: > + - const: rockchip,sfc Use 'enum' instead of oneOf+const. You need an SoC specific compatible. > + > + reg: > + maxItems: 1 > + > + interrupts: > + maxItems: 1 > + > + clocks: > + items: > + - description: Bus Clock > + - description: Module Clock > + > + clock-names: > + items: > + - const: clk_sfc > + - const: hclk_sfc Do you have these backwards? 'hclk' is usually an AHB bus clock. Also, '_sfc' is redundant. > + > + power-domains: > + maxItems: 1 > + > + rockchip,sfc-no-dma: > + description: Disable DMA and utilize FIFO mode only > + type: boolean > + > +patternProperties: > + "^flash@[0-3]$": > + type: object > + properties: > + reg: > + minimum: 0 > + maximum: 3 > + > +required: > + - compatible > + - reg > + - interrupts > + - clocks > + - clock-names > + > +unevaluatedProperties: false > + > +examples: > + - | > + #include <dt-bindings/clock/px30-cru.h> > + #include <dt-bindings/interrupt-controller/arm-gic.h> > + #include <dt-bindings/power/px30-power.h> > + > + sfc: spi@ff3a0000 { > + compatible = "rockchip,sfc"; > + reg = <0xff3a0000 0x4000>; > + interrupts = <GIC_SPI 56 IRQ_TYPE_LEVEL_HIGH>; > + clocks = <&cru SCLK_SFC>, <&cru HCLK_SFC>; > + clock-names = "clk_sfc", "hclk_sfc"; > + pinctrl-0 = <&sfc_clk &sfc_cs &sfc_bus2>; > + pinctrl-names = "default"; > + power-domains = <&power PX30_PD_MMC_NAND>; > + #address-cells = <1>; > + #size-cells = <0>; > + > + flash@0 { > + compatible = "jedec,spi-nor"; > + reg = <0>; > + spi-max-frequency = <108000000>; > + spi-rx-bus-width = <2>; > + spi-tx-bus-width = <2>; > + }; > + }; > + > +... > -- > 2.17.1
