On Mon, 31 May 2021 16:32:43 +0300, Oleh Kravchenko wrote: > A simple analog joystick built on Low Power ATtiny85 Microcontroller. > Directional movements are measured with two 10 kΩ potentiometers > connected with a gimbal mechanism that separates the horizontal and > vertical movements. This joystick also has a select button that is actuated > when the joystick is pressed down. > > Input events polled over the I2C bus. > > Product page: > https://www.sparkfun.com/products/15168 > Firmware and hardware sources: > https://github.com/sparkfun/Qwiic_Joystick > > Tested on RPi4B and O4-iMX-NANO boards. > > Cc: Benjamin Tissoires <benjamin.tissoires@xxxxxxxxxx> > Cc: Device Tree mailing list <devicetree@xxxxxxxxxxxxxxx> > Cc: Dmitry Torokhov <dmitry.torokhov@xxxxxxxxx> > Cc: Jiri Kosina <jikos@xxxxxxxx> > Cc: Patchwork Bot <patchwork-bot@xxxxxxxxxx> > Signed-off-by: Oleh Kravchenko <oleg@xxxxxxxxxx> > --- > .../bindings/input/qwiic-joystick.yaml | 31 ++++ > .../devicetree/bindings/vendor-prefixes.yaml | 2 + > drivers/input/joystick/Kconfig | 9 + > drivers/input/joystick/Makefile | 1 + > drivers/input/joystick/qwiic-joystick.c | 169 ++++++++++++++++++ > 5 files changed, 212 insertions(+) > create mode 100644 Documentation/devicetree/bindings/input/qwiic-joystick.yaml > create mode 100644 drivers/input/joystick/qwiic-joystick.c > My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check' on your patch (DT_CHECKER_FLAGS is new in v5.13): yamllint warnings/errors: dtschema/dtc warnings/errors: Documentation/devicetree/bindings/input/qwiic-joystick.example.dts:21.13-26: Warning (reg_format): /example-0/qwiic@20:reg: property has invalid length (4 bytes) (#address-cells == 1, #size-cells == 1) Documentation/devicetree/bindings/input/qwiic-joystick.example.dt.yaml: Warning (pci_device_reg): Failed prerequisite 'reg_format' Documentation/devicetree/bindings/input/qwiic-joystick.example.dt.yaml: Warning (pci_device_bus_num): Failed prerequisite 'reg_format' Documentation/devicetree/bindings/input/qwiic-joystick.example.dt.yaml: Warning (simple_bus_reg): Failed prerequisite 'reg_format' Documentation/devicetree/bindings/input/qwiic-joystick.example.dt.yaml: Warning (i2c_bus_reg): Failed prerequisite 'reg_format' Documentation/devicetree/bindings/input/qwiic-joystick.example.dt.yaml: Warning (spi_bus_reg): Failed prerequisite 'reg_format' /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/input/qwiic-joystick.example.dt.yaml: example-0: qwiic@20:reg:0: [32] is too short From schema: /usr/local/lib/python3.8/dist-packages/dtschema/schemas/reg.yaml /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/input/qwiic-joystick.example.dt.yaml: qwiic@20: 'reg' does not match any of the regexes: 'pinctrl-[0-9]+' From schema: /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/input/qwiic-joystick.yaml See https://patchwork.ozlabs.org/patch/1485677 This check can fail if there are any dependencies. The base for a patch series is generally the most recent rc1. If you already ran 'make dt_binding_check' and didn't see the above error(s), then make sure 'yamllint' is installed and dt-schema is up to date: pip3 install dtschema --upgrade Please check and re-submit.
