As the name implies, the USB2 controller should only operate at
USB2 speeds. Make sure it does just that by pinning it to USB
High-Speed (USB2) mode.
Signed-off-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/msm8996.dtsi | 2 ++
1 file changed, 2 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/msm8996.dtsi b/arch/arm64/boot/dts/qcom/msm8996.dtsi
index 12afd49e0097..08a6e2b5a54b 100644
--- a/arch/arm64/boot/dts/qcom/msm8996.dtsi
+++ b/arch/arm64/boot/dts/qcom/msm8996.dtsi
@@ -2588,6 +2588,7 @@ usb2: usb@76f8800 {
assigned-clock-rates = <19200000>, <60000000>;
power-domains = <&gcc USB30_GDSC>;
+ qcom,select-utmi-as-pipe-clk;
status = "disabled";
dwc3@7600000 {
@@ -2596,6 +2597,7 @@ dwc3@7600000 {
interrupts = <0 138 IRQ_TYPE_LEVEL_HIGH>;
phys = <&hsusb_phy2>;
phy-names = "usb2-phy";
+ maximum-speed = "high-speed";
snps,dis_u2_susphy_quirk;
snps,dis_enblslpm_quirk;
};
--
2.31.1
