Re: [RESEND PATCH V4 3/8] arm64: dts: qcom: pm7325: Add pm7325 base dts file

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 2021-05-18 22:12, Matthias Kaehlcke wrote:
On Tue, May 18, 2021 at 05:16:27PM +0530, Vinod Koul wrote:
On 18-05-21, 11:50, satya priya wrote:
> Add base DTS file for pm7325 along with GPIOs and temp-alarm nodes.
>
> Signed-off-by: satya priya <skakit@xxxxxxxxxxxxxx>
> Reviewed-by: Matthias Kaehlcke <mka@xxxxxxxxxxxx>
> ---
> Changes in RESEND V4:
>  - No Changes.
>
>  arch/arm64/boot/dts/qcom/pm7325.dtsi | 53 ++++++++++++++++++++++++++++++++++++
>  1 file changed, 53 insertions(+)
>  create mode 100644 arch/arm64/boot/dts/qcom/pm7325.dtsi
>
> diff --git a/arch/arm64/boot/dts/qcom/pm7325.dtsi b/arch/arm64/boot/dts/qcom/pm7325.dtsi
> new file mode 100644
> index 0000000..e7f64a9
> --- /dev/null
> +++ b/arch/arm64/boot/dts/qcom/pm7325.dtsi
> @@ -0,0 +1,53 @@
> +// SPDX-License-Identifier: BSD-3-Clause
> +// Copyright (c) 2021, The Linux Foundation. All rights reserved.
> +
> +#include <dt-bindings/interrupt-controller/irq.h>
> +#include <dt-bindings/spmi/spmi.h>
> +
> +&spmi_bus {
> +	pm7325: pmic@1 {
> +		compatible = "qcom,pm7325", "qcom,spmi-pmic";

where is qcom,pm7325 documented?


good point, I missed that one.


Actually this point was discussed during V2( https://lore.kernel.org/patchwork/patch/1406186/#1607321 ). As far as I understand it is not mandatory to add "qcom,pm7325" as we are adding "qcom,spmi-pmic". It is just a good to have change. I could not find the documentation for pm8350c, pmk8350 and pmr735a as well.

> +		reg = <0x1 SPMI_USID>;
> +		#address-cells = <1>;
> +		#size-cells = <0>;
> +
> +		pm7325_temp_alarm: temp-alarm@a00 {
> +			compatible = "qcom,spmi-temp-alarm";
> +			reg = <0xa00>;
> +			interrupts = <0x1 0xa 0x0 IRQ_TYPE_EDGE_BOTH>;
> +			#thermal-sensor-cells = <0>;
> +		};
> +
> +		pm7325_gpios: gpios@8800 {
> +			compatible = "qcom,pm7325-gpio", "qcom,spmi-gpio";

where is qcom,pm7325-gpio documented?

It's added by the 'Add GPIO support for PM7325' series
(https://patchwork.kernel.org/project/linux-arm-msm/list/?series=481133)

The binding change was acked by Rob and the code by Bjorn, so it can be
expected to land, but it would still be good to mention the dependency
explicitly.

The binding patch is applied now.

Thanks,
Satya Priya



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux