On Tue, May 18, 2021 at 05:16:27PM +0530, Vinod Koul wrote:
> On 18-05-21, 11:50, satya priya wrote:
> > Add base DTS file for pm7325 along with GPIOs and temp-alarm nodes.
> >
> > Signed-off-by: satya priya <skakit@xxxxxxxxxxxxxx>
> > Reviewed-by: Matthias Kaehlcke <mka@xxxxxxxxxxxx>
> > ---
> > Changes in RESEND V4:
> > - No Changes.
> >
> > arch/arm64/boot/dts/qcom/pm7325.dtsi | 53 ++++++++++++++++++++++++++++++++++++
> > 1 file changed, 53 insertions(+)
> > create mode 100644 arch/arm64/boot/dts/qcom/pm7325.dtsi
> >
> > diff --git a/arch/arm64/boot/dts/qcom/pm7325.dtsi b/arch/arm64/boot/dts/qcom/pm7325.dtsi
> > new file mode 100644
> > index 0000000..e7f64a9
> > --- /dev/null
> > +++ b/arch/arm64/boot/dts/qcom/pm7325.dtsi
> > @@ -0,0 +1,53 @@
> > +// SPDX-License-Identifier: BSD-3-Clause
> > +// Copyright (c) 2021, The Linux Foundation. All rights reserved.
> > +
> > +#include <dt-bindings/interrupt-controller/irq.h>
> > +#include <dt-bindings/spmi/spmi.h>
> > +
> > +&spmi_bus {
> > + pm7325: pmic@1 {
> > + compatible = "qcom,pm7325", "qcom,spmi-pmic";
>
> where is qcom,pm7325 documented?
good point, I missed that one.
> > + reg = <0x1 SPMI_USID>;
> > + #address-cells = <1>;
> > + #size-cells = <0>;
> > +
> > + pm7325_temp_alarm: temp-alarm@a00 {
> > + compatible = "qcom,spmi-temp-alarm";
> > + reg = <0xa00>;
> > + interrupts = <0x1 0xa 0x0 IRQ_TYPE_EDGE_BOTH>;
> > + #thermal-sensor-cells = <0>;
> > + };
> > +
> > + pm7325_gpios: gpios@8800 {
> > + compatible = "qcom,pm7325-gpio", "qcom,spmi-gpio";
>
> where is qcom,pm7325-gpio documented?
It's added by the 'Add GPIO support for PM7325' series
(https://patchwork.kernel.org/project/linux-arm-msm/list/?series=481133)
The binding change was acked by Rob and the code by Bjorn, so it can be
expected to land, but it would still be good to mention the dependency
explicitly.
